In culture experiments and many low temperature environments, the distribution of isoprenoid glycerol dialkyl glycerol tetraethers (GDGTs) commonly shows a strong correlation with temperature; however, this is often not the case in hot springs. We studied 26 hot springs in Yunnan, China, in order to determine whether temperature or other factors control the distribution of GDGTs in these enviro...

A spraying evaporation system applied to brine disposal is reported, which is mainly used for disposing the brine with concentration more than 100,000 mg/L. A computational fluid dynamics (CFD) simulation has been carried out to study the brine droplet evaporation and diffusion process in high temperature air flow. A discrete-phase model in spraying evaporation system is developed and a simulat...

INTRODUCTION This study compared simulated temperature distributions of intraluminal heating devices, concerning penetration and homogeneity. A hot water balloon, a 434-MHz monopole and a 915-MHz dipole antenna, both with incorporated cooling, and a 27-MHz applicator were investigated. METHODS The hot water balloon had an inlet temperature of 45 degrees C and a flow rate of 7.85 ml s(-1). The...

The deep cryogenic treatment is a complementary operation that is done on a variety of tool steels aimed at improving their abrasion resistance and hardness. In the case of the H13 hot-work steel, which is widely used at high temperatures as a hot-deformation tool, we need to determine the efficiency of subzero treatment on it at the working temperature. In this regard, this paper is focu...

Legionella-contaminated hot water systems and moist sanitary areas in six hospitals were sampled for amoebae by following a standardized collection protocol. Genus identifications and temperature tolerance determinations were made. Amoebae identified as Hartmannella vermiformis (65%), Echinamoebae spp. (15%), Saccamoebae spp. (12%), and Vahlkampfia spp. (9%) were detected in 29 of 56 (52%) hot ...

This paper modeled heating air of a room through examining free convection in a 3D chamber. The chamber had cold and hot sources with Tc and Th temperatures, respectively. Its other walls were adiabatic. This study aimed at predicting effect of temperature difference, displacement of hot and cold sources and their aspect ratio on flow field, temperature and heat transfer rate. To conduct the st...

Summer temperature extremes over the global land area were investigated by comparing 26 models of the fifth phase of the Coupled Model Intercomparison Project (CMIP5) with observations from the Goddard Institute for Space Studies (GISS) and the Climate Research Unit (CRU). Monthly data of the observations and models were averaged for each season, and statistics were calculated for individual mo...

Hybridization efficiency of two crossing methods (involving emasculation by hot water or by anther aspiration), was determined in rice. Quantitative comparisons between crossing methods for pure line breeding are scarce and the objectives of this work were to evaluate the advantages and disadvantages of emasculation methods, and to determine an adequate temperature for hot water emasculation. H...

A viscoplastic deformation model considering material damage is used to predict hot tear formation in a permanent mold magnesium alloy casting. The simulation model calculates the solid deformation and ductile damage. The viscoplastic constitutive theory accounts for temperature dependent properties and includes creep and isotropic hardening. Ductile damage theory is used to find mechanically i...

Thermal remediation techniques, such as hot water flooding, are emerging technologies that have been proposed for the removal of nonaqueous phase liquids (NAPLs) from the subsurface. In this study a combined laboratory and modeling investigation was conducted to determine if hot water flooding techniques would improve NAPL mass removal compared to ambient temperature water flushing. Two experim...