-Theoretical and experimental studies dealing with the spray ignition phenomena are reviewed. Two major topics covered are external-source ignition of liquid fuel sprays and spontaneous spray ignition. Experimental and theoretical investigations of external-source ignition of sprays employing different configurations are discussed first. Three major topics included here are: (i) ignition of qui...

Ignition is the initial stage of burning the materials. Consequent flame spread over the materials, heat release rate, fire spread across the rooms, and other issues for building fires all depend on that. Ignition of cellulose materials is commonly classified as smoldering or glowing ignition (self-heating ignition) and flaming ignition including piloted and spontaneous ignition. Numerous studi...

High-speed digital imaging has been used in rapid compression facility (RCF) studies to investigate ignition phenomena of iso-octane/air mixtures. Sequential images were captured for each experiment. The results indicate the existence of two ignition regimes. In one domain, ignition is rapid, typically less than 76 μs, and ignition occurs simultaneously throughout the test volume. In the other ...

“Ignition/extinction” phenomena and steady-state multiplicity were discovered in an autohumidi$cation polymer electrolyte membrane fuel cell. At steady state, the water produced by the fuel cell reaction is balanced by water removal by the 7owing reactant gas streams. Ignition, corresponding to a high fuel cell current, arises from positive feedback between the water produced by the reaction an...

Lagrangian PDF investigations are performed of the Sandia piloted flame E and the Cabra H2/N2 lifted flame to help develop a deeper understanding of local extinction, re-ignition and auto-ignition in these flames, and of the PDF models’ abilities to represent these phenomena. Lagrangian particle time series are extracted from the PDF model calculations and are analyzed. In the analysis of the r...

To realize large-percentage biomass co-firing with coal in existing coal-fired boilers, the combustion behavior of biomass is expected to be similar or comparable to that of coal. When co-firing with coal, biomass is not necessarily to be ground as fine as the dedicated coal particles, because of its higher reactivity. With the objective of achieving promising performance of co-firing with dedi...

In order to understand better the auto-ignition process in an HCCI engine, the influence of some important parameters on the auto-ignition is investigated. The inlet temperature, the equivalence ratio and the compression ratio were varied and their influence on the pressure, the heat release and the ignition delays were measured. The inlet temperature was changed from 25 to 70 °C and the equiva...