cupric oxide nanostructures were synthesized via a simple reaction between copper nitrate and sodium hydroxide using a sonochemical-assisted method. the synthesized cuo was then characterized using x-ray diffraction, scanning electron microscopy, transmission electron microscopy, fourier transform infrared, ultraviolet-visible and photoluminescence spectroscopy. our studies show that the cuo na...

Body-fixed motion sensors have been applied for the assessment of sit-to-stand (STS) performance. However, the accuracy and concurrent validity of sensor-based estimations of the body's center of mass (CoM) motion during STS are unclear. Therefore, this study investigated the accuracy and concurrent validity of sensor-based measures of CoM motion during STS in older adults. Accuracy and concurr...

In this paper the development of an inertial sensor for vibration measurements based on the use of ferrofluids is presented. The use of ferrofluids as inertial mass offers advantages over traditional devices like robustness against inertial shocks and performances controllable via electrical signals; moreover, ferrofluids density and other physical features can be controlled by an external magn...

Sensor performance of a dielectric filled silicon bulk acoustic resonator type label-free biosensor is verified with biotin-streptavidin binding interactions as a model system. The mass sensor is a micromachined silicon square plate with a dielectric filled capacitive excitation mechanism. The resonance frequency of the biotin modified resonator decreased 315 ppm when exposed to streptavidin so...

Influence of electromagnetic interferences on the gravimetric sensitivity of surface acoustic waveguides. Abstract Surface acoustic waveguides are increasing in interest for (bio)chemical detection. The surface mass modification leads to measurable changes in the propagation properties of the waveguide. Among a wide variety of waveguides, Love mode has been investigated because of its high grav...

In this study, a magnetoelastic resonance microbalance (MERM) was used to directly measure the gas-phase adsorption behavior of water vapor, isopropyl alcohol, and acetone on a sol-gel-derived titanium dioxide sensor coating. The nature of the MERM platform enables chemical measurements in situations in which wires or physical connections are undesired (or not possible) or in which sensor cost ...

Distributed sensing of gas-phase chemicals using highly sensitive and inexpensive sensors is of great interest for many defense and consumer applications. In this paper we present ppb-level detection of dimethyl methylphosphonate (DMMP), a common simulant for sarin gas, with a ppt-level resolution using an improved capacitive micromachined ultrasonic transducer (CMUT) as a resonant chemical sen...

This paper proposes a fiber Bragg grating sensing-based micro-vibration sensor. The optical fiber has been directly treated as an elastomer to design the micro-vibration sensor, which possesses two FBGs. The mass is fixed on the middle of the fiber, and the vertical vibration of the mass has been converted into the axial tension/compression of the fiber. The principle of the sensor has been int...

Micro fabricated accelerometer sensors have been developed to measure acceleration in a variety of applications, including automobile airbag crash sensors and seismic activity monitors. For this thesis a three-dimensional accelerometer sensor is used for measuring involuntary human hand motion (tremor). This human hand motion sensor uses three singleaxis accelerometers fabricated with a free sc...

Direct chemical sensing in liquid environments using polymer-guided shear horizontal surface acoustic wave sensor platforms on 36 degrees rotated Y-cut LiTaO3 is investigated. Design considerations for optimizing these devices for liquid-phase detection are systematically explored. Two different sensor geometries are experimentally and theoretically analyzed. Dual delay line devices are used wi...