Tomatoes are a high-value crop all over the world, including Ethiopia. Tomato ripening is highly dependent on ethylene action as climacteric fruit, making this fruit perishable in short period of time. Pre-storage treatments such CaCl 2 and edible coatings essential for preserving quality after harvest extending shelf life. The purpose study was to determine effect tomato postharvest experiment...

several investigations have been devoted towards understanding the coating process in fluidized beds. most of these studies focused on spraying liquid droplets over the bed. however, due to the complexity of these systems, more investigations are still required to quantify the effect of operating conditions on the coating criteria. the present work aims at fundamentally understanding and precis...

Researchers have been focused on the influences of flowing fluid on the corrosion of bare metals, but there is little emphasis on the degradation of metal-protective coating. Evaluating the metal-protective coating usually uses the Electrochemical Impedance Spectroscopy (EIS) method. EIS is a technique used for evaluating coating permeability or barrier performance based on the electrical imped...

Novel scaffolds composed of poly(L-lactic acid) (PLLA) skeleton covered with bonelike apatite or apatite/collagen composite were produced via a combined phase-separation technique and an accelerated biomimetic coating process. Saos-2 osteoblast-like cells were used to evaluate the cellular behaviors on these biomimetic coatings. Cell morphologies on the surfaces of PLLA scaffolds, PLLA scaffold...

in this research, b4c-ni cermet coating was sprayed on the surface of 4130 steel from b4c and ni feed-stockpowders using high velocity oxy-fuel (hvof) method. in order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 n.phase analysis of the coating after spraying was studied by x-ray diffracto...

A novel cobalt-free Cu1.2Mn1.8O4 spinel coating is prepared and evaluated for the metal interconnect of solid oxide fuel cell. Mn-35Cu and Co-35Mn alloy coatings are deposited on 430 SS substrate and then in-situ oxidized in air at 750 ◦C for 100 h. XRD results confirm that Cu1.2Mn1.8O4 spinel with some Mn2O3 is formed, and the average thickness of the coating is 70–80 μm according to cross sec...