The objective of this study was to develop suitable cooling systems for high-power multichip LEDs. To this end, three different active cooling systems were investigated to control the heat generated by the powering of high-power multichip LEDs in two different configurations (30 and 2 × 15 W). The following cooling systems were used in the study: an integrated multi-fin heat sink design with a ...

Thermal Management in the present issue modern era. The technology heat transfer day by is increased gradually especially electronic device, space applications, hybrid vehicles, solar heater. These are major areas where management successfully research going on Pulsating Heat Pipe a two phase device takes place through sensible and latent heat. This paper gives an over review of pipe design, wo...

This paper presents the fabrication and application of a micro-scale hybrid wicking structure in a flat polymer-based heat pipe heat spreader, which improves the heat transfer performance under high adverse acceleration. The hybrid wicking structure which enhances evaporation and condensation heat transfer under adverse acceleration consists of 100 μm high, 200 μm wide square electroplated copp...

in this work, three-dimensional turbulent forced convection flow through a b-type section pipe, which porous material inserted at the bottom wall, is investigated numerically. the b-type section pipe are used in cooling systems, such as cars’ radiators. the main purpose of this research is to enhance heat transfer and to reduce the scales of such systems. the governing equations are formulated ...

A theoretical study is conducted to explore the effect of different parameters on the performance of a Loop Heat Pipe (LHP). These parameters are evaporator temperature, condenser temperature, total mass charge, the tube size of piping system, and pumping distance between evaporator and condenser. This paper pres ents a steady state model that describes the thermodynamics, heat transfer, and fl...

in this research, heat transfer enhancement and simultaneous effect of that on pressure drop inside condensers with twisted tape inserts are investigated. a refrigeration system is designed for attaining to maximum level of heat transfer with minimum pressure drop. the test condenser is a double pipe heat transformer with inner and outer diameter of 10.7mm and 12.7mm for internal pipe, respecti...

Hydronic heating systems that circulate a heated fluid through pipes embedded in a bridge deck or roadway may be used to eliminate or reduce dangerous driving conditions caused by snow and ice. The first important task in sizing such a system is determining the required heat flux. Current guidance in the ASHRAE HVAC Applications Handbook for required surface heat fluxes is based on a one-dimens...

A large heat load caused by thermal radiation through a metal shield pipe was observed in a cooling test of a cryostat for a prototype of a cryogenic interferometric gravitational wave detector. The heat load was approximately 1000 times larger than the value calculated by the Stefan-Boltzmann law. We studied this phenomenon by simulation and experiment and found that it was caused by the condu...