Oscillatory measurements of a columnar structure were performed, which was formed in an immiscible polymer blend subjected to an electric field. The formation process was observed through a confocal scanning laser microscope and the structure for the measurements was confirmed to be well defined. The storage shear modulus at low frequencies increased with increasing the electric field. A linear...

In the electronics industry epoxy molding compounds, underfills and adhesives are used for the packaging of electronic components. These materials are applied in liquid form, cured at elevated temperatures and then cooled down to room temperature. During these processing steps residual stresses are built up resulting from both cure and thermal shrinkage. These residual stresses add up to the st...

This paper derives conditions for localized deformation for a transversely isotropic constitutive relation intended to model the response of geological materials in the axisymmetric compression test. The analysis considers the possibility of shear bands, with dilation or compaction, and pure compaction bands. The latter are planar zones of localized pure compressive deformation (without shear) ...

BACKGROUND Altered muscle activation during pain is thought to redistribute stress within muscles and ultimately decrease the load on painful structures. However, change in muscle stress during pain has not been directly tested. The aim of the present study is to determine whether stress within muscle tissue is reduced during local acute experimental pain. METHODS AND RESULTS Ten participants...

We show that the Lorentz shear modulus of macroscopically homogeneous electronic states in the lowest Landau level is proportional to the bulk modulus of an equivalent system of interacting classical particles in the thermodynamic limit. Making use of this correspondence, we calculate the Lorentz shear modulus of Laughlin's fractional quantum Hall states at filling factor ν = 1/m (m an odd inte...

We propose a Widom-like scaling ansatz for the critical jamming transition. Our ansatz for the elastic energy shows that the scaling of the energy, compressive strain, shear strain, system size, pressure, shear stress, bulk modulus, and shear modulus are all related to each other via scaling relations, with only three independent scaling exponents. We extract the values of these exponents from ...

In this paper, the effect of reclaimed rubber modification on the rheological characteristics of asphalt binders is studied. Reclaimed rubber with the extent of 12, 16 and 20 is added to the neat asphalt binder and then shear complex modulus is obtained for neat and modified asphalt binder via Dynamic Shear Rheometer (DSR) test. Using Christensen-Anderson- Marasteanu (CAM) model, master curves ...

Expressions are given for the maximum and minimum values of Poisson’s ratio ν for materials with cubic symmetry. Values less than −1 occur if and only if the maximum shear modulus is associated with the cube axis and is at least 25 times the value of the minimum shear modulus. Large values of |ν| occur in directions at which the Young’s modulus is approximately equal to one half of its 111 valu...

This work outlines the etiological factors for exercise-related foot blisters and the pertinent prevention strategies related to these causes. Blisters result from shear forces within the epidermis causing cell necrosis. The extent of skin shear is influenced by friction at the skin and other interfaces, various skin characteristics, bony movement, and the shear modulus of the foot ware. The nu...

Background Medial tibial stress syndrome (MTSS) is one of the most common causes of exercise-related leg pain in runners. Because stopping training due to pain from MTSS could decrease the athlete's competitiveness, it is necessary to construct MTSS prevention and treatment programs. However, the effect of running, which is believed to cause MTSS, on shear elastic modulus of the posterior lower...