The electro discharge machining (EDM), one of the methods used in the machining industry and a non-traditional manufacturing method, the electro erosion process does not depend on the hardness of material and offers a way to process materials of very complex geometry with very fine and high precision by using cheap electrode materials, which make it a preferred method. In this study, effect of ...

We report on the effect of femtosecond-laser-induced periodic surface structures (LIPSS) on the tribological properties of stainless steel. Uniform periodic nanostructures were produced on AISI 304L (American Iron and Steel Institute steel grade) steel surfaces using an 800-nm femtosecond laser. The spatial periods of LIPSS measured by field emission scanning electron microscopy ranged from 530...

BACKGROUND Total meniscectomy has been shown to cause early-onset arthritis in the underlying cartilage and bone in the knee joint, demonstrating that the meniscus plays an important protective role in the load carrying capacity. Relationships between friction and wear in synovial joints are complex due to the biphasic nature of articular cartilage and the time dependency of tribological respon...

The electro discharge machining (EDM), one of the methods used in the machining industry and a non-traditional manufacturing method, the electro erosion process does not depend on the hardness of material and offers a way to process materials of very complex geometry with very fine and high precision by using cheap electrode materials, which make it a preferred method. In this study, effect of ...

The role of contact pressure on skin friction has been documented in multiple experimental studies. Skin friction significantly raises in the low-pressure regime as load increases while, after a critical pressure value is reached, the coefficient of friction of skin against an external surface becomes mostly insensitive to contact pressure. However, up to now, no study has elucidated the qualit...

The effects of different surface roughness models on a previously developed van der Waals adhesion model were examined. The van der Waals adhesion model represented surface roughness with a distribution of hemispherical asperities. It was found that the constraints used to define the asperity distribution on the surface, which were determined from AFM scans, varied with scan size and thus were ...

OBJECTIVE To investigate the role of the superficial zone in regulating the frictional response of articular cartilage. This zone contains the superficial protein (SZP), a proteoglycan synthesized exclusively by superficial zone chondrocytes and implicated in reducing the friction coefficient of cartilage. DESIGN Unconfined compression creep tests with sliding of cartilage against glass in sa...

Atmospheric plasma spraying is used to deposit alumina and alumina-graphite composite coatings. The influence of arc current (plasma temperature) on the microstructure, roughness, elemental composition, phase composition coatings analyzed by scanning electron microscopy (SEM), surface roughness testing, energy dispersive X-ray spectroscopy (EDX), diffraction (XRD). tribological properties spray...

IN T R O D U C T IO N It is generally agreed that a wet pavement surface presents less resistance to skidding than does the same surface in a dry condition. It is also well known that ice and snow are very slippery; but on the other hand, they are special conditions which do not reflect any skid characteristic of the pavement surface. It is, therefore, the wet surface condition that is critical...