optimization of machining parameters is very important and the main goal in every machining process. surface finishing prediction is a pre-requirement to establish a center for automatic machining operations. in this research, a neuro-fuzzy approach is used in order to model and predict the surface roughness in dry turning. this approach has both the learning capability of neural network and li...

Surface roughness plays an important role in the adhesion of small particles. In this paper we have investigated adhesion as a geometrical effect taking into account both the particle size and the size of the surface features. Adhesion is studied using blunt model particles on surfaces up to 10 nm root-mean-square (RMS) roughness. Measurements with particles both smaller and larger than surface...

this work presents an experimental investigation of the influence of the six important machining parameters (tool nose radius, tool rake angle, feed rate, cutting speed, cutting environment (dry, wet and cooled) and depth of cut) on surface roughness & material removal rate in the machining unidirectional glass fiber reinforced plastics (ud-gfrp) composite using carbide (k10) cutting tool durin...

OBJECTIVES To challenge the problem of slipperiness, various slipmeters have been developed to assess slip hazard. The performance of in-situ slipmeter is, however, still unclear under the various floor conditions. The main objectives of this study were to evaluate the performance of three kinds of slipmeters under real conditions, and to find their dynamic and kinematic characteristics, which ...

turning of hardened steels using a single point cutting tool has replaced the cylindrical grinding now as it offers attractive benefits in terms of lower equipment costs, shorter set up time, fewer process setups, higher material removal rate, better surface quality and elimination of cutting fluids compared to cylindrical grinding. in order to obtain desired surface quality by machining, prope...

the first step in studying dust events is the estimation of dust emission from sources. in this study, the simulations of the vertical dust flux (vdf) over iran by the mba (marticorena, bergametti, and alfaro) and shao schemes are compared. the mba scheme is energy-based and derived on the basis of energy balance between the kinetic energy of saltating particles and binding energy of the surfac...

the vibratory finishing is one of the important mass finishing processes. this can be applied for finishing many metallic and non- metallic components using abrasive materials such as steel, ceramic, natural materials and etc. the vibratory finishing process is used for some purposes such as surfaces polishing, deburring, oxide layer removing and rounding the edges. evaluation of surface roughn...

Capillary adhesion is commonly present in ambient conditions. It can be measured single-asperity contacts through atomic force microscopy using a sharp probe that pulled off smooth substrate. However, for macroscopic multiasperity interfaces, the adhesive always close to zero because of elastic energy stored into deformation surface roughness; this known as paradox. Here, we experimentally show...

In this study electrical discharge process was used to increase surface wear resistance of pure aluminum. Pulse-on-time and pulse current were considered as input parameters of the electrical discharge process. Experimental results reveal that the electrical discharge process is a successful method for improving the surface wear resistance of aluminum, so that this method has greatly increased ...