Creep and shrinkage are such properties that will occur in concrete when they are under load and exposed to surrounding. Since this property will cause deformation which may decrease the design strength of the concrete, it is necessary to do have more knowledge on this phenomenon. So, we will study the effect of creep on 7 and 14 days of cured time of specimens which sealed or unsealed will be ...

The objective of these experiments was to test the hypothesis that the "creep currents" induced by Na loading of single frog atrial cells (Hume, J. R., and A. Uehara. 1986. Journal of General Physiology. 87:833) may be generated by an electrogenic Na/Ca exchanger. Creep currents induced by Na loading were examined over a wide range of membrane potentials. During depolarizing voltage-clamp pulse...

We present creep experiments on fiber composite materials. Recorded strain rates and acoustic emission (AE) rates exhibit both a power law relaxation in the primary creep regime and a power-law acceleration before global failure. In particular, we observe time-to-failure power laws in the tertiary regime for acoustic emissions over four decades in time. We also discover correlations between som...

The 60 min creep data from National Type Evaluation Procedure (NTEP) tests performed at the National Institute of Standards and Technology (NIST) on 65 load cells have been analyzed in order to compare their creep and creep recovery responses, and to compare the 60 min creep with creep over shorter time periods. To facilitate this comparison the data were fitted to a multiple-term exponential e...

The tail tendons from wallabies (Macropus rufogriseus) suffer creep rupture at stresses of 10 MPa or above, whereas their yield stress in a dynamic test is about 144 MPa. At stresses between 20 and 80 MPa, the time-to-rupture decreases exponentially with stress, but at 10 MPa, the lifetime is well above this exponential. For comparison, the stress on a wallaby tail tendon, when its muscle contr...

Interpreting channel behavior in patches requires an understanding of patch structure and dynamics, especially in studies of mechanosensitive channels. High resolution optical studies show that patch formation occurs via blebbing that disrupts normal membrane structure and redistributes in situ components including ion channels. There is a 1-2 microm region of the seal below the patch where pro...

The effects of microstructures during creep on the ultrasonic attenuation have been investigated for Ni based superalloy (IN738LC). The cuboidal γ′ precipitates in the virgin material became coarsened preferentially in the direction perpendicular to the applied stress axis as creep time increased. The length of γ′ precipitates increased with creep time, while the width increased slightly. The i...

Creep response of a full-scale floor system fabricated with composite wood I-joists and oriented strand board (OSB sheathing) was measured for 280 days at sustained uniform loads of 20 psf (0.96 kPa). Creep responses of bare I-joists and 3-joist T-beams with OSB sheathing (glued and unglued tongue and groove sheathing joints) were measured under similar load levels and duration. The creep defle...

The influence of wall thickness and specimen surface on the creep behavior single-crystal nickel-based superalloy MAR M247LC is studied. Specimens with thicknesses 0.4, 0.8, 1 2 mm, without casting surface, are compared to specimens same prepared from bulk material. Creep turned out be independent conditions even for thinnest specimens. debit effect not pronounced short rupture times (?100 h at...

This paper presents the application of a life fraction hardening rule to the analytical calculation of creep in hot section components. Accurate prediction of creep is critical to assuring the mechanical integrity of heavy-duty, industrial gas turbine (IGT) hardware. The accuracy of such predictions depend upon both the creep models assumed and how those models are implemented in a finite eleme...