Partial discharge inside a transformer is mainly responsible for the insulation aging and damage of the transformer. However, partial discharge is usually accompanied by external signals like sound, light and electrical signals and detectable physical phenomena such as characteristical gas and dielectric loss. Therefore, it is of great significance to monitor online the external signals and phe...

An overview of the research and developments into new transformer design, undertaken in the Department of Electrical and Computer Engineering, University of Canterbury, is presented. Initially, single phase, 50 Hz, l1/0.23kV pole mount distribution transformers were fitted with either silicon or amorphous steel cores. The transformer tanks were filled with either standard transformer oil or liq...

Transformer insulating oil nanofluid is made to improve dielectric and thermal properties of the oil by employing nanoparticles with proper properties. In the current work, nanofluids based on transformer mineral oil were prepared by three procedures using diamond nanoparticles with high thermal conductivity, as well as high dielectric properties. It was tried to consider the impacts of surfact...

The largest loss in an example litz-wire flyback transformer is found during current commutation between windings. In order to reduce this loss, a new optimization method is introduced. The new method optimizes strand size and number in litz wire considering cost and loss. Unlike previous methods, it is valid with twoor three-dimensional field geometry and with different non-sinusoidal waveform...

This paper proposes a stochastic optimization method, based on ant colony optimization, for the optimal choice of transformer sizes to be installed in a distribution network. This method is properly introduced to the solution of the optimal transformer sizing problem, taking into account the constraints imposed by the load the transformer serves throughout its life time and the possible transfo...

The Hot Spot Temperature (HST) value depends on the ambient temperature, the rise in the top oil temperature (TOT) over the ambient temperature, and the rise in the winding HST over the top oil temperature. In this paper a new semi-physical model comprising of the environmental variables for the estimation of HST and loss of insulation life in transformer is proposed. The winding hot-spot tempe...

The main goal of this paper is the determination of the effect of the metal oxide varistor (MOV) on various ferroresonance modes including fundamental resonance, subharmonic and chaos mode which are generated in electrical power systems. Chaos theory is used for analyzing this effect. Also, the bifurcation, phase plan diagram and time domain simulation are used for this purpose. The proposed po...

A new approach for power combining several low-voltage CMOS amplifiers using a new on-chip transmission line transformer structure is presented. The power combiner utilises the interconnection of short sections of integrated differential lines and has an efficiency independent of the transformation ratio. Full-wave electromagnetic simulation confirms the operation and low insertion loss of the ...

In this paper, a new approach to build a dual-band impedance transformer is presented. The transformer can handle impedances that are complex and vary with frequency. This transformer contains a Pi-section structure, which can be equivalent to having two different electrical lengths at the two operating frequencies. One of the electrical lengths serves as complementary angle of the other. In th...

Power transformers represent the largest portion of capital investment in transmission and distribution substations. In addition, power transformer outages have a considerable economic impact on the operation of an electrical network. One of the most important parameters’ governing a transformer’s life expectancy is the hot-spot temperature value. Due to under estimation of stray losses in powe...