The present paper is concerned with the effective numerical implementation of the two-dimensional dual boundary element method, for linear elastic crack problems. The dual equations of the method are the displacement and the traction boundary integral equations. When the displacement equation is applied on one of the crack surfaces and the traction equation on the other, general mixed-mode crac...

A new method is proposed for shape sensitivity analysis of a crack in a homogeneous, isotropic, and nonlinearly elastic body subject to mode I loading conditions. The method involves the material derivative concept of continuum mechanics, domain integral representation of the J-integral, and direct differentiation. Unlike virtual crack extension techniques, no mesh perturbation is required in t...

The effect of stitching on mode I and mode II strain energy release rates for debond configurations is studied using an analysis based on plate finite elements and the virtual crack closure technique. The stitches were modeled as discrete nonlinear fastener elements with a compliance determined by experiment. The axial and shear behavior of the stitches was considered with both the compliances ...

using computation software to simulate fracture behaviors of structures can shorten the time to estimate safety of engineering structures and reduce a lot of cost of experiment. However three dimensional numerical simulation for fracture process is a challenging issue, because the convergence and accuracy are not easily obtained and high computational cost is generated. In this paper, three new...

A detailed model of the role of asperities in crack closure has been initiated in Part 1 of this article. Crack opening stress is defined as the far-field stress required to overcome the asperity-induced contact stresses along the crack. In this Part 2, the magnitude of crack opening stress is established as a function of roughness (s0); asperity density (N); maximum stress level (Smax/Sy); sha...

A modified strip-yield model has been developed to simulate the plasticity-induced crack closure under the constant amplitude (CA) and a single overload loading conditions. The paper focuses on the simulation of the near tip crack profiles and stress distributions during the fatigue process. Detailed information on near-tip stress and displacement fields at the maximum load (Pmax), the minimum ...

Mechanisms for fatigue crack closure under plane strain conditions have recently been identified at very low (near-threshold) stress intensities in terms of effects of excess corrosion deposits or fracture surface roughness in promoting premature closure of the crack. In the present paper, a geometric model is presented for crack closure induced by fracture surface roughness. This model specifi...

Using cold working fastener holes is a simple life enhancement procedure that strengthens metallic components by retarding crack growth around a hole. In the present paper, the residual stress field that is induced by the hole expansion process is obtained based on different material models namely elastic perfect plastic, isotropic hardening and kinematic hardening using three-dimensional finit...

Fatigue crack growth was investigated in a 001 1⁄2 oriented single crystal specimen, made of a Ni-based superalloy, Haynes 230. Crack propagation was characterized with digital image correlation: crack closure, measured by analyzing the relative displacements of crack flanks, showed closure levels much lower than polycrystal alloys. Reversed plastic zones were calculated from regressed stress i...

Based on the theory of elasticity, previous analytical solutions concerning a penny-shaped interface crack employ the derivative of the crack surface opening displacements as the primary unknowns, thus leading to singular integral equations with Cauchy-type singularity. The solutions to the resulting integral equations permit only the determination of stress intensity factors and energy release...