Aluminum matrix composites reinforced with Al2O3 and SiC particles (5 Vol%) were produced using the hot powder extrusion method. Extrusion temperature and extrusion reduction in area were chosen in the range of 500 to 600°C and 90 to 95%, respectively. The physical and mechanical properties of the extruded composites such as density, tensile strength, elongation and microhardness were evaluated...

Aluminum matrix composites reinforced with Al2O3 and SiC particles (5 Vol%) were produced using the hot powder extrusion method. Extrusion temperature and extrusion reduction in area were chosen in the range of 500 to 600°C and 90 to 95%, respectively. The physical and mechanical properties of the extruded composites such as density, tensile strength, elongation and microhardness were evaluated...

The hydrostatic extrusion is a new method of extrusion process. The most important advantage of this method is reduction of friction and close tolerance for the coating thickness. In this study, the hydrostatic extrusion simulation of bimetallic wires has performed using of finite element method. In the following the advantages of hydrostatic extrusion compared to the direct extrusion are prese...

The present study involves a novel computational technique, regarding simultaneous use of the pseudo particle method, Poisson integral method and a special-purpose computer originally designed for molecular dynamics simulations (MDGRAPE-3). In the present calculations, the dynamics of two colliding vortex rings have been studied using the vortex method. The present acceleration technique allows...

This paper is about experimental results for partial reduction of vortex at vertical pipe intakes. One of the easiest and practical ways of reducing vortex effect is to use anti-vortex plates or baffles. These plates can be used to avoid the vortex completely or partially. This paper will concentrate on the latter case. Rectangular plates with different dimensions have been placed at different ...

in this paper the effect of block shape vortex generators (vgs) on an air-water fin-tube heat exchanger has been studied experimentally using exergy analysis method. also the effect of these vgs on increasing heat transfer rate has been simulated numerically and the results show a good agreement with the experiments. in this research we used a wind tunnel to produce wind flow over heat exchange...

Hot-melt extrusion is one of the most widely applied processing technologies in the plastic, rubber and food industry. Today this technology has found its place in the array of pharmaceutical manufacturing operations. Melt extrusion process are currently applied in the pharmaceutical field for the manufacture of a variety of dosage forms and formulations such as granules, pellets, tablets, supp...

Rectangular waveguide is one of the earliest types of transmission lines. Rectangular waveguide can be produced by hot extrusion process. In this paper, the hot extrusion process of CuZn5 rectangular waveguide was investigated by Finite Element Method (FEM). In addition, Genetic Algorithm (GA) was used to optimize the die geometry and process conditions to achieve the lowest magnitude of extrus...