conclusions according to the results, it can be concluded that the titanium catalyst doped with iron (fe+3-tio2) processes is an appropriate method for reducing atrazine in polluted water resources. results the results demonstrated that the atrazine removal rate increased by decreasing the initial atrazine concentration and the maximum rate of atrazine removal (41.72%) was at ph = 11, atrazine ...

The synthesis of three bifunctional phosphonium salts bearing perfluorinated side chains is reported. These compounds were employed as catalysts for the cyclic carbonates from epoxides and CO2. most efficient catalyst comprised a phenolic substructure allowed various at room temperature CO2 pressure low 0.1 MPa. reaction could be performed in perfluorodecalin which some cases led to improved yi...

In this paper, using Coriandrum sativum L., a leaf-extracted, assisted microwave method (MM) was used to synthesize nickel oxide formation. We synthesized nickel oxide nanoparticles (NiO) with a crystal size in the range of 15-16 nm by a Coriandrum sativum leaf-assisted microwave method (LAMM). The synthesized materials show that an X-ray diffraction (XRD) study confirmed the formation of a sin...

The simultaneous combination of steady state isotopic transient kinetic analysis (SSITKA) with diffuse reflectance Fourier transform spectroscopy (DRIFTS) and mass spectrometric (MS) analysis was applied to study the oxidative carbonylation of methanol (MeOH) to dimethyl carbonate (DMC) on a CuY zeolite catalyst prepared by incipient-wetness impregnation of commercial zeolite NH(4)-Y. The inter...

In this scientific research, MnO2 nanoparticles (NPs) have been successfully prepared by a precipitation method using KMnO4, MnSO4.H2O and H2O2 (30%) as the precursors. As-prepared sample was identified by X-ray diffraction (XRD), Scanning electron microscopy (SEM), Transmission electron microscopy (TEM) and Infrared (IR) techniques. The transmission electron microscopy (TEM) showed 7-8 nm rang...

In this scientific research, MnO2 nanoparticles (NPs) have been successfully prepared by a precipitation method using KMnO4, MnSO4.H2O and H2O2 (30%) as the precursors. As-prepared sample was identified by X-ray diffraction (XRD), Scanning electron microscopy (SEM), Transmission electron microscopy (TEM) and Infrared (IR) techniques. The transmission electron microscopy (TEM) showed 7-8 nm rang...

here, we have synthesized vertically aligned carbon nanotubes (va-cnts), using chemical vapor deposition (cvd) method. cobalt and ethanol are used as the catalyst and the carbon source, respectively. the effects of ethanol flow rate, thickness of co catalyst film, and growth time on the properties of the carbon nanotube growth are investigated. the results show that the flow rate of ethanol and...

Automobile catalyst emissions have resulted in the occurrence of elevated Pt, Pd, and Rh concentration in the urban and roadside environment. We investigate the chronology of platinum group elements (PGE) accumulation in dated sediments from an urban lake near Boston, MA. Chronological profiles demonstrate that Pt, Pd, and Rh concentrations increased following the introduction in catalysts with...

A novel generic method of silica supported catalyst system generation from a fluid state is presented. The technique is based on the combined flow and radiation (such as microwave, thermal or UV) induced co-assembly of the support and catalyst precursors forming nano-reactors, followed by catalyst precursor decomposition. The transformation from the precursor to supported catalyst oxide state c...

The technical feasibility of using calcium oxide (CaO) as a sorbent for CO2 and Fe-Cr as a catalyst for the water-gas shift (WGS) reaction using syngas for the steam gasification of biomass was investigated. The effects of temperature, steam to biomass mass ratio, CaO to biomass molar ratio, and Fe-Cr WGS catalyst on gas composition were studied. Within a temperature range of 250 C to 550 C, ...