Wear of the surface is the major problem of all materials. This wear can be of many types and there can be several methods of reducing wear. Coating on the surface of material is one of them. On M.S substrate, thermal spray coating is done using Detonation spray gun and coating powders used is a mixture of oxides (Al2O3-13TiO2). The thermal-sprayed coatings are characterized by SEM, EDS analyse...

Al7075 alloy reinforced with h-Boron Nitrate (BN) composites were processed by stir casting technique. The produced composite was subjected to microstructural studies using OLYMPUS -BX51M, tensile, hardness, density and wear tests. Tensile strength and hardness were found to increase by 12.8% and 20% respectively due to increased dislocation density with the addition of reinforcement. Microstru...

In this study, the effect of cladded tungsten carbide layer upon HSS - M2 tool steel on microstructure, hardness, and wear behavior has been studied in two cases without using the middle layer and using the middle layer of nickel. Tungsten Carbide cladded on HSS - M2 tool steel by Arc Weld ( SMAW ). The ASTM-G65 wear test was used to determine its application for use in the mineral indus...

BACKGROUND AND PURPOSE Wear rates of highly crosslinked polyethylene (XLPE) acetabular components have varied considerably between different published studies. This variation is in part due to the different techniques used to measure wear and to the errors inherent in measuring the relatively low amounts of wear in XLPE bearings. We undertook a scoping review of studies that have examined the i...

Influence of initial surface roughness on friction and wear processes under fretting conditions was investigated experimentally. Rough surfaces (Ra=0.15-2.52 μm) were prepared on two materials: carbon alloy (AISI 1034) and titanium alloy (Ti-6Al-4V). Strong influence of initial surface roughness on friction and wear processes is reported for both tested materials. Lower coefficient of friction ...

Wear experiments have shown that when the applied normal stress exceeds a critical value, a transition occurs from the regime of mild wear to that of adhesive wear. As a result, the wear rate of particle-reinforced aluminium composites increases by a hundred-fold. Based on dislocation and delamination theories, a criterion is proposed for determining the critical transition load, and a quantita...

We consider fretting wear due to tangential oscillations of two contacting bodies. For small oscillation amplitudes, the wear occurs only in a circular slip zone at the border of the contact area. With increasing number of cycles, the wear profile tends to a limiting form, in which no further wear occurs. Under assumption of a constant coefficient of friction, the limiting form of the wear prof...

OBJECTIVE To classify wear and non-wear time of accelerometer data for accurately quantifying physical activity in public health or population level research. DESIGN A bi-moving-window-based approach was used to combine acceleration and skin temperature data to identify wear and non-wear time events in triaxial accelerometer data that monitor physical activity. SETTING Local residents in Sw...

Femoral components of hip replacements are commonly anchored in the femur with bone cement or poly(methyl methacrylate) (PMMA). Wear or fracture of bone cement can lead to loosening of the femoral component, which drastically affects the success and longevity of hip replacements. Self-reinforced composite PMMA (SRC-PMMA) has been previously developed for potential use, as a precoat material for...

In gears running under conditions of high load and low circumferential speed the lubricant film thickness is often not sufficient to fully separate the mating surfaces. Wear of the gear flanks can occur and can even result in total gear failure. For a given gear geometry the main influencing parameters are load, circumferential speed and lubricant. The wear characteristics of lubricants depend ...