The tool wear of cutting tools has a very strong impact on product quality as well as on the efficiency of machining processes overall. Despite the current high automation level in the machining industry, a few key issues prevent complete automation of the entire turning process. One of these issues is tool wear, which is usually measured off the machine tool and is still done by hand under a t...

In rock drilling, bit wear is a major factor in determining bit life, the cost of drilling and may significantly influence the drilling method selected for given rock type. Effective control of bit wear can yield significant cost savings. Prediction of cuttability or drillability requires an understanding of the cutting action and the mode of wear and their interaction with the rock propertiesW...

The objective of the present study is to analyze and compare the cutting performance of segmented diamond blades when dry-cutting concrete. A cutting criteria is proposed to characterize the wear of the blades by measuring the variation of the external diameter and the weight loss of the blade. The results exhibit the cutting blade SB-A, which has twice the density of diamonds and large contact...

Increased surface roughness and wear of resin cements may cause failure of indirect restorations. The aim of this study was to evaluate quantitatively the surface roughness change and the vertical wear of four resin cements subjected to mechanical toothbrushing abrasion. Ten rectangular specimens (15 × 5 × 4 mm) were fabricated according to manufacturer instructions for each group (n = 10): Nex...

Liner design is becoming an increasingly more important tool for the AG/SAG mill performance optimization. The Gol-E-Gohar iron ore concentration plant uses three 9 m × 2.05 m autogenous mills (AG) in parallel in a dry operation. Due to large variations in feed characteristics and inadequate blending, the performance of AG mills has been lower than the target value. In order to increase the cir...

We propose a novel, on-machine method of measuring the profile of the cutting edge of a tool by using the cutting fluid on the tool surface. Despite an environment of on-machine tool profile measurement, it is difficult to measure a cutting edge profile by using conventional optical methods due to interference from the cutting fluid on the tool surface. To overcome this problem, we propose a pr...

This paper outlines the historical development of the wheel and rail profiles currently used on railway vehicles. It also presents the key damage mechanisms involved in wheel-rail contact and summarises the methods that have recently been developed by railway engineers to predict the level of wheel and rail damage from these mechanisms. Tools for predicting the key damage modes of wear and roll...

A 16-station wear simulator of the pin-on-disc type, called RandomPOD, was designed, built, and validated. The primary area of application of the RandomPOD is wear studies of orthopaedic biomaterials. The type of relative motion between the bearing surfaces, generally illustrated as shapes of slide tracks, has been found to have a strong effect on the type and amount of wear produced. The compu...

Dentinogenesis imperfecta type II or hereditary opalscent dentin is one of the most common autosomal dominant anomaly of dentin that occurs in both sex affecting approximately 1:8000 persons. Clinically this disorder is characterized by variable blue gray to yellow brown teeth, with fracture of enamel and excessive wear. The treatment strategy is focused towards protecting teeth from further we...

BACKGROUND The association between oral hygiene habits & practices and severity of tooth wear lesion varies from community to community and also from occupation to occupation. The present study was conducted with to assess oral hygiene habits & practices and tooth wear among fertilizer factory workers of Punjab, India. MATERIAL AND METHODS A descriptive cross sectional survey was conducted am...