forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. in this research, forming limit diagram (fld) of ss304l sheet was obtained by abaqusfinite element software. in practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. forming limit di...

This paper presents the fracture analyses conducted on the FAA/NASA stiffened and unstiffened panels using the STAGS (STructural Analysis of General Shells) code with the critical crack-tip-opening angle (CTOA) fracture criterion. The STAGS code with the “plane-strain” core option was used in all analyses. Previous analyses of wide, flat panels have shown that the high-constraint conditions aro...

Formability of Tailor Welded Blank (TWB) is an important parameter which limits this kind of blanks usage. A forming criterion for tailor welded blank is presented based on the analytical model in this research. This criterion suggests Limit Strength Ratio (LSR) and Limit Thickness Ratio (LTR) for forming limit of TWB. When thickness ratio or strength ratio in tailor welded blank is greater tha...

Molecular dynamics (MD) simulations are used to directly observe nucleation of median cracks in oxide glasses under indentation. Indenters with sharp angles can nucleate median cracks in samples with no pre-existing flaws, while indenters with larger indenter angles cannot. Increasing the tip radius increases the critical load for nucleation of the median crack. Based upon an independent set of...

in this paper, the mean value of strain energy density criterion has been used to predict the critical fracture load in specimens with u-shaped notch under bending loads. an equation for calculation of averaged strain energy density in this zone has been presented. bending loads under mode i have been considered. two cases have been studied: 1) the control volume only includes the semicircular ...