A high-linearity and high-speed current-mode sampleand-hold circuit is designed and simulated using a 0.25μm CMOS technology. This circuit design is based on low voltage and it utilizes a fully differential circuit. Due to the use of only two switches the switch related noise has been reduced. Signal dependent -error is completely eliminated by a new zero voltage switching technique. The circui...

This paper presents a novel high step-down DC-DC converter based on switched-capacitor resonant topology. It is presented in 48/8 V version, which was verified by simulations and experiments. The most notable features specific to this are an almost non-iductive design relatively low voltage stress across switching devices. proposed topology allows for zero-current-switching (ZCS) zero-voltage-s...

This paper presents the design of integrated Dead-Time-Locked Loops (DTLL) for a fixed-frequency Zero-Voltage-Switching QuasiSquare-Wave (ZVS-QSW) buck converter. This is developed to address the challenges of DC/DC conversion for next-generation high-performance microprocessors. The DTLLs provide real-time accurate dead-time control with fast error rejection to realize ZVS, which minimizes swi...

In this paper three single-phase, high-power-factor rectifier implementations were evaluated on a comparative basis. Specifically, a zero-voltage-switching continuousconduction-mode boost rectifier, a zero-current-zero-voltageswitching continuous-conduction-mode boost rectifier, and an interleaved variable-frequency discontinuous-conduction-mode boost rectifier were compared with respect to the...

The soft switching of a flyback converter can be achieved by operating the circuit in the critical conduction mode. However, the critical-mode operation at light loads cannot be maintained due to a very high switching frequency and the loss of the output voltage regulation. A control which regulates the output down to the zero load and maintains soft switching at light loads is proposed. The pr...

In this paper, in order to achieve zero ripple conditions, the use of a ripple mirror (RM) circuit for the boost converter is proposed. The operation modes are studied and steady-state analyses performed to show the merits of the proposed converter. It is found that the proposed RM circuit technique can provide much better flexibility than the two-phase interleaved boost converter for locating ...

This thesis presents High frequency Soft Switching DC-DC boost Converter. The circuit consists of a general Boost Converter with an additional resonant circuit which has a switch, inductor, capacitor and a diode.In general Boost Converter circuits have snubber circuits where switching losses are dissipated in external passive resistors; which is known as hard switching. As the switching frequen...

In this paper, an interleaved soft switching boost converter for a Photovoltaic Power Conditioning System (PV-PCS) with high efficiency is proposed. In order to raise the efficiency of the proposed converter, a 2-phase interleaved boost converter integrated with soft switching cells is used. All of the switching devices in the proposed converter achieve zero current switching (ZCS) or zero volt...