The goal of the present research is to develop a better understanding of the tensile response of open-cellular aluminum 6061 T6 alloy. Both tensile and compression samples of this metallic foam were tested under constant strain rate conditions at 293, 423, and 523 K. Scanning electron microscopy was performed on individual struts to assess the modes and mechanisms associated with fracture. Theo...

Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...

High-speed machining is considered to be a promising technique due its advantages, such as high productivity and better product quality. With paradigm shift towards sustainable practices, the energy consumption analysis of high-speed also gaining ever-increasing importance. The current article addresses this issue presents detailed specific cutting (SCE) surface finish (Ra) during conventional ...

Joining of the similar & dissimilar materials alloys using heat friction in currently being used, especially for non-ferrous which are considered as non-weldable alloys. Al 2024-T6 6061-T6 having length 70mm and 12mm diameter were welded by welding process. Similar samples obtained applying different combinations parameters like pressure 30bar, forging from 50 to 60 bar, rotational speed 22...

12.7-mm thick plates of 6061-T6511 aluminum alloy and high hardness steel (528 HV) were successfully joined by a friction stir bonding process using a tungsten Process parameter variation experiments, which geometry, plunge and traverse rates, tool offset, spindle tilt, and rotation speed, were conducted to develop a parameter set which yielded a defect free joint. Laboratory tensile tests exhi...

This paper presents the design of a fiber-coupled self-mixing laser diode (SMLD) for non-contact and non-destructive measurement of Young's modulus. By the presented measuring system, the Young's modulus of aluminum 6061 and brass are measured as 70.0 GPa and 116.7 GPa, respectively, showing a good agreement within the standards in the literature and yielding a much smaller deviation and a high...

We demonstrate a three phase-grating moiré neutron interferometer in a highly intense neutron beam as a robust candidate for large area interferometry applications and for the characterization of materials. This novel far-field moiré technique allows for broad wavelength acceptance and relaxed requirements related to fabrication and alignment, thus circumventing the main obstacles associated wi...

We report experimental observations on the evolution of acoustic entropy in the course of cyclic loading as degradation occurs due to fatigue. The measured entropy is a result of the materials’ microstructural changes that occur as degradation due to cyclic mechanical loading. Experimental results demonstrate that maximum acoustic entropy emanating from materials during the course of degradatio...