STATEMENT OF PROBLEM In some clinical situations, the length of either a prepared tooth or an implant abutment is shorter than ideal, and the thickness of a porcelain crown must be increased. Thickness of the coping and the veneering porcelain should be considered to prevent mechanical failure of the crown. PURPOSE The purpose of this study was to investigate the influence of veneering porcel...

Porcelain gallbladder is rare manifestation of chronic cholecystitis. calcification of the gallbladder wall is present between 0.06%-0.8% of cholecystectomy specimens. the pathogenesis is still unknown but it is believed that it caused by irritation the gallbladder by stones which lead to chronic inflammation associated with calcium deposit. calcification of the gallbladder wall is associated w...

This work presents the effect of room temperature vulcanized (RTV) silicone rubber coating on cap and pin type porcelain insulator under ac (50Hz) flashover voltage (KV). Describes experimental results obtained for improvement of porcelain insulator removed from 33kV overhead transmission line at Aswan, Egypt after 28 years of service. Also, this study briefly surveys the environmental contamin...

In the two decades since establishment of people’s Republic China, challenges facing porcelain production have changed significantly. Porcelain is one most important and oldest traditions in China. 1950s, craftsmen became involved creation new forms interior plastics. Many pieces they created are now part museum collections represent history development Chinese porcelain. Using example three mu...

The ultimate goal for an esthetic rehabilitation is the restoration of health, beauty, and function to the patient. This article illustrates a predictable system to guide the clinician with tooth preparations for porcelain veneer restorations based upon the additive diagnostic wax-up. This system promotes a preparation technique using a series of guides that direct the clinician to reduce only ...

PURPOSE To compare the effects of different porcelain surface treatment methods on the shear bond strength (SBS) and fracture mode of orthodontic brackets. MATERIALS AND METHODS Seventy feldspathic porcelain disk samples mounted in acrylic resin blocks were divided into seven groups (n=10) according to type of surface treatment: I, Diamond bur; II, Orthosphoric acid (OPA); III, hydrofluoric a...

STATEMENT OF PROBLEM Recent clinical results for Zirconia all-ceramic restorations have revealed that the fracture rate 6-15% of the Zirconia framework is so low and the core of Zirconia has high stability. However, chipping-off fractures of porcelain are the most common reason for failures of Zirconia in the fixed partial dentures. OBJECTIVES The purpose of this study was to compare the shea...

STATEMENT OF THE PROBLEM The success of metal- ceramic- restorations (MCR) depends on the presence of strong bond between porcelain and metal substructure. PURPOSE The purpose of this study was to evaluate the effect of hot pressing technique on the bond strength of a metal-porcelain composite in comparison to layering technique. MATERIALS AND METHOD Thirty Nickel-Chromium specimens were pr...

The aim of this study was to assess whether surface treatment improves zirconia-porcelain adhesion. The 3Y-TZP blocks were cut into squares, then polished and sintered. The zirconia surface treatments were performed as follows: no treatment (C); tribochemical silica coating (TBS); glaze application + hydrofluoric acid etching (GA); glaze application + hydrofluoric acid etching + silanization (G...