The material flow and microstructural evolution in the friction stir welds of a 6061-Al alloy to itself and of a 6061-Al alloy to 2024-Al alloy plates of 12.7 mm in thickness were studied under different welding conditions. The results showed that plastic deformation, flow, and mechanical mixing of the material exhibit distinct asymmetry characteristics at both sides of the same and dissimilar ...

The effect of heat treatment at 520oC on Si and Mg in 6061/5% volume Ni3Alp composite was investigated. Si atoms diffused through the Al3Ni reaction product to form a Sicontaining Al3Ni2 phase with variable amounts of Si, whereas Mg accumulated at matrixAl3Ni interphases. As a consequence, the 6061 alloy lost its age harden ability.

Particle effects on friction and wear of 6061 aluminium (6061 AI) reinforced with silicon carbide (SIC) and alumina (AI203) particles were investigated by means of Vickers microhardness measurements and scratch tests. Unreinforced 6061 AI matrix alloy was also studied for comparison. To explore the effect of heat treatment, materials subjected to three different heat treatment conditions, i.e. ...

The failure response of aluminum alloys (Al-6061 and Al-7075) under the condition of simultaneously pre-stressing and laser heating was investigated. Specimens were subjected to predetermined preloading states and then irradiated by continuous wave fiber (Yb) laser. For all specimens, it was found that the yield stress decreased with increasing laser power density. This implies that the load-be...

A nanocarbon-infused aluminum-matrix composite, termed "covetic," has been developed by Third Millennium Metals, LLC, and we have evaluated the enhanced performance prospects for strength and electrical conductivity. This paper examines the effects of the nanoscale carbon on the physical, electrical and mechanical properties of the metal-matrix composite based on microscopy, hardness, quasi-sta...

A three-dimensional numerical model is used to simulate the Friction Stir Welding (FSW) process using the computational fluid dynamics package ‘FLUENT’. Two mechanical models: the Couette and the Visco-Plastic fluid flow models for Al-6061-T6 were simulated. The simulation results are compared to experimental data for Al 6061-T6 welded at high rotational (1500–5000 rpm) and travel speeds rangin...

0261-3069/$ see front matter 2010 Elsevier Ltd. A doi:10.1016/j.matdes.2010.08.008 ⇑ Corresponding author. Address: School of Mechan ing, Nanyang Technological University, 50 Nanyang Republic of Singapore. Tel.: +65 6790 5588; fax: +65 E-mail address: [email protected] (Z.W. Zhon In this study, a rapidly solidified aluminum alloy was compared with beryllium copper and 6061 aluminum alloys in ...

AA 6061 has gathered wide acceptance in the fabrication of the light structures required to high strength. Compared to the fusion welding processes that are used for joining structural aluminium alloys, friction stir welding (FSW) process is an emerging solid state joining process in which the material that is being welded does not melt and recast. In this experimental work, an extensive invest...

clicking here. colleagues, clients, or customers by , you can order high-quality copies for your If you wish to distribute this article to others here. following the guidelines can be obtained by Permission to republish or repurpose articles or portions of articles ): December 8, 2011 www.sciencemag.org (this infomation is current as of The following resources related to this article are avai...

because of high strength to weight ratio, 6061 aluminum has many applications in different industries like automotive and aerospace industries and can help to reduction of fuel consumption. forming limit diagram (fld) is a useful method for sheet metal formability identification. whereas calculation of forming limit diagram by experimental tests is expensive and time consumption, in the present...