11.9 W Output Power at S-band from 1 mm AlGaN/GaN HEMTs

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

High Power SSPA Based on GaN HEMTs for S-band Military Radars

In this paper, we have developed a high power solid-state power amplifier (SSPA) for Sband military radars. The SSPA consists of a high power amplifier (HPA) module combined GaN based power amplifier pallets, a drive amplifier (DA) module, a digital control module and a power supply unit. The SSPA shows the total output power of 62 dBm in S-band.

متن کامل

264 W output power at 1585 nm in Er-Yb codoped fiber laser using in-band pumping.

We demonstrate a high-power cladding-pumped Er-Yb codoped fiber laser with 74% efficiency. A pump-limited output power of 264 W is obtained using in-band pumping at 1535 nm. We compare the efficiency of 1480 and 1535 nm pumping through numerical simulations and experimental measurements.

متن کامل

Quantum cascade laser master-oscillator power-amplifier with 1.5 W output power at 300 K.

We report quantum cascade laser (QCL) master-oscillator power-amplifiers (MOPAs) at 300 K reaching output power of 1.5 W for tapered devices and 0.9 W for untapered devices. The devices display single-longitudinal-mode emission at λ = 7.26 µm and single-transverse-mode emission at TM(00). The maximum amplification factor is 12 dB for the tapered devices.

متن کامل

Current Status of X-Band and Ku-Band High Power GaN HEMTs

あらまし GaN HEMTの高周波高出力の一例として X帯 50 W級,100 W級,並びに Ku帯 50 W級 GaN HEMT の技術課題と解決方法,特性例について述べる.GaN HEMT は出力電力密度が高い一方で,その発熱 密度も高い.発熱量を抑えるためには高い効率,そのために高い利得が必要である.X-Ku 帯において利得を上 げるために,フィールドプレートを用いない電流コラプス低減対策,Via-hole を用いたソース接地を適用した. その結果,X 帯 100 W 級 GaN HEMT では,飽和出力電力 51.1 dB(129 W),最大電力付加効率は 47.8%を 得た.Ku帯 50 W級 GaN HEMTでは,飽和出力電力 47.3 dBm(53 W),最大電力付加効率は 33.2%を得た. 最後にいくつかの実用例を紹介した. キーワード GaN HEMT,電力付加効...

متن کامل

Beam-Cavity Interaction Circuit at W-Band

We describe the design, fabrication and bench-study of a mm-wave cavity employed as a relativistic klystron output structure. The OFE copper cavity was prepared by electrodischarge machining and diffusion bonding, cleaned, and tuned to 91.4 GHz. Measured cavity characteristics are presented and compared with theory, including quality factor, Q, coupling parameter ß, scattering matrix S11, and a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: ECS Transactions

سال: 2019

ISSN: 1938-6737

DOI: 10.1149/1.2983173