6.78-MHz Class E Power Amplifier with Low Output Power Variation against the Load Impedance Variation
نویسندگان
چکیده
A power amplifier structure is presented that has a low output variation against the load impedance at 6.78 MHz using two Class E amplifiers and λ/4 transmission line. with another high are connected in parallel phase difference of 90° Each generates same under nominal conditions to achieve maximum efficiency. The can be reduced during operation, which increases from one decreases time when changed value. Therefore, efficiency maintained better compared conventional balanced structure. experiments show proposed an 16.18 %–18.4 6% less than For high-power mode both amplifiers, 13.54–21.53 W 75.41 %–80.16 % were obtained. An 4.67–8.76 77.89 %–82.48 obtained low-power mode, only operates.
منابع مشابه
A Class E Power Amplifier with Low Voltage Stress
A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...
متن کاملa class e power amplifier with low voltage stress
a new output structure for class e power amplifier (pa) is proposed in this paper. a series lc resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. this resonator causes low impedance at the second harmonic. the output circuit is designed to shape the switch voltage of the class e amplifier and lower the voltage stress of the transistor. t...
متن کاملA Class E Power Amplifier with Low Voltage Stress
A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...
متن کاملA Cmos Low Voltage Class-e Power Amplifier for Umts
In this paper we design a low-voltage class-E power amplifier (PA) in a standard CMOS 0.35μm integrated technology, to be used in a UMTS transceiver having the following specifications: f=1.95 GHz, VDC=1 V, Pout=0.5 W. The designed class-E network accommodates the simultaneous presence of a parasitic ground inductance and losses in the switch and shunt-capacitor. The transistor is dimensioned f...
متن کاملLow Power SI Class E Power Amplifier and RF Switch For Health Care
This research was to design a 2.4 GHz class E Power Amplifier (PA) for health care, with 0.18um Semiconductor Manufacturing International Corporation CMOS technology by using Cadence software. And also RF switch was designed at cadence software with power Jazz 180nm SOI process. The ultimate goal for such application is to reach high performance and low cost, and between high performance and lo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2022
ISSN: ['2288-226X', '1226-3133']
DOI: https://doi.org/10.5515/kjkiees.2022.33.8.599