A 2.6 ppm/°C 2.5 V Piece-Wise Compensated Bandgap Reference with Low Beta Bipolar
نویسندگان
چکیده
منابع مشابه
3 ppm Ultra Wide Range Curvature Compensated Bandgap Reference
In this report a current mode bandgap with a temperature coefficient of 3 ppm for the range from -117◦C to 144◦C is presented. 2nd order curvature compensation is used by using a third BJT with a temperature constant current and a second error amplifier to get a nonlinear temperature coefficient current in extra to enhance the accuracy. The required minimum supply voltage is 1.3V for 3ppm and 1...
متن کاملA Curvature-Corrected Low-Voltage Bandgap Reference
A new curvature-corrected bandgap reference is presented which is able to function at supply voltages as low as 1 V, at a supply current of only 100 PA. After trimming this bandgap reference has a temperature coefficient (TC) of +4 ppm/OC. The reference voltage is about 200 mV and it can simply be adjusted to higher reference voltages, The temperature range of this circuit is from O to 125” C. ...
متن کاملCMOS Bandgap Voltage Reference With 1.8-V Power Supply
To overcome the limitation of the silicon energy gap in electron volts 1.2V wluch leads to tllat the voltage reference is fixed at about 1.2V. a design of current-mode (CM) architecture CMOS bandgap voltage reference with afiitnry voltage value by setting tlie resistor value is presented liere with Ion 1.8-V power supply. Tlie siniiilation results indicate a temperature coefficient (TC) of jppm...
متن کاملSub-1-V-Output CMOS bandgap reference circuit with small area and low power consumption
In this paper, a new low-VDD CMOS bandgap reference circuit with small layout area and low power consumption is proposed. The proposed circuit delivering its output voltage below 1V has its Proportional-To-Absolute-Temperature (PTAT) term compensated by the Complementary-proportional-To-AbsoluteTemperature (CTAT) voltage thereby suppressing a change in its output voltage regardless of temperatu...
متن کاملDesign of a 1-v Low Power Cmos Bandgap Reference Based on Resistive Subdivision
A design of a CMOS bandgap reference (BGR), for portable applications with medium accuracy, is described and the measurement results of the fabricated chips are presented. The output voltage of the reference is set by resistive subdivision. In order to achieve small area and low power consumption, n-well resistors are used. This design features a reference voltage of 0.750 V with 1σ variation o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics
سال: 2019
ISSN: 2079-9292
DOI: 10.3390/electronics8050555