A micromachined Kelvin probe with integrated actuator for microfluidic and solid-state applications
نویسندگان
چکیده
منابع مشابه
Microfluidic cell sorter with integrated piezoelectric actuator
We demonstrate a low-power (<0.1 mW), low-voltage (<10 V(p-p)) on-chip piezoelectrically actuated micro-sorter that can deflect single particles and cells at high-speed. With rhodamine in the stream, switching of flow between channels can be visualized at high actuation frequency (micro1.7 kHz). The magnitude of the cell deflection can be precisely controlled by the magnitude and waveform of in...
متن کاملIntegrated microfluidic probe station.
The microfluidic probe (MFP) consists of a flat, blunt tip with two apertures for the injection and reaspiration of a microjet into a solution--thus hydrodynamically confining the microjet--and is operated atop an inverted microscope that enables live imaging. By scanning across a surface, the microjet can be used for surface processing with the capability of both depositing and removing materi...
متن کاملMicrocalorimetry applications of a surface micromachined bolometer-type thermal probe
This article describes a surface micromachined scanning thermal probe that uses polyimide as the structural material and an embedded thin film metal resistor as the sensing element. The typical dimensions of a fabricated probe are 350 mm in length, 50 mm in width, and 3–10 mm in thickness. The resistor and the scanning tip are formed by sputter-deposited films of nickel and tungsten, which prov...
متن کاملMicromachined Heat Exchanger for a Cryosurgical Probe
This paper describes a lithography-based microfabrication process developed for a recuperative heat exchanger intended for use in a cryosurgical probe. The probe, which uses the Joule-Thomson (JT) cooling cycle, must achieve a temperature < -50°C, with a freeze rate of 25-50°C/min. The heat exchanger must maintain high stream-to-stream thermal conductance while restricting parasitic stream-wise...
متن کاملSolid State NMR Probe Design
The majority of solids NMR experiments today are driven by biological applications in rigid macromolecules, where even the most advanced liquids methods are limited by the spectral resolution they can achieve. Obtaining detailed structural information from NMR of solid samples is often more technically demanding than for liquids because of the absence of molecular tumbling in solids to average ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Microelectromechanical Systems
سال: 2005
ISSN: 1057-7157
DOI: 10.1109/jmems.2005.845453