A simple photonic generation of linearly chirped microwave pulse with large time-bandwidth product and high compression ratio
نویسندگان
چکیده
منابع مشابه
Pulse compression with time-domain optimized chirped mirrors.
Dispersive optical interference coatings (chirped mirrors - CMs) are designed by computer optimization of an analytically calculated initial multilayer. Traditionally, the relevant properties of the CM (reflectance and the frequency-dependence of the phase shift upon reflection) are optimized to match frequency-domain targets. We propose a novel target function that quantifies directly the capa...
متن کاملLarge delay-bandwidth product and tuning of slow light pulse in photonic crystal coupled waveguide.
This paper reports two advances in a slow light device consisting of chirped photonic crystal slab coupled waveguide on SOI substrate. One is concerning the delay-bandwidth product, indicating the buffering capacity of the device. We experimentally evaluated a record high value of 57 (a 40 ps delay and a 1.4 THz bandwidth). We also observed ~1 ps wide optical pulse transmission in the cross-cor...
متن کاملHigh power femtosecond chirped pulse amplification in large mode area photonic bandgap Bragg fibers
We report on high power amplification of femtosecond pulses in 40-μm core diameter Yb-doped photonic bandgap Bragg fibers. The robustness to bending and transverse spatial behavior of these fibers is analyzed through simulations. The fibers are used in both stages of a moderately stretched (150 ps) femtosecond chirped pulsed amplification (CPA) system. A compressed average power of 6.3 W is obt...
متن کاملPhotonic generation of phase-coded microwave signals based on optical pulse shaping and time delay
A novel approach to photonic generation of phase-coded microwave signals based on optical pulse shaping and time delay is proposed. In the proposed approach, an optical short pulse train is inserted with a specified amount of time-delay to certain pulses, and then converted into super-Gaussian microwave pulses based on the optical pulse shaping technique. By properly adjusting the time-delay, p...
متن کاملWave-breaking-extended fiber supercontinuum generation for high compression ratio transform-limited pulse compression.
Wave-breaking often occurs when a short intense optical pulse propagates in a long normally dispersive optical fiber. This effect has conventionally been avoided in fiber (super-)continuum-based pulse compression because the accumulated frequency chirp of the output pulse cannot be fully compensated by a standard prism (or grating) pair. Thus, the spectral extending capability of the wave-break...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2013
ISSN: 1094-4087
DOI: 10.1364/oe.21.023107