Absorptive K-Band Bandpass Filter Using a Balanced Recursive Structure
نویسندگان
چکیده
منابع مشابه
Design and Analysis of Ultra-wide Band Bandpass Filter Using Spiral Stub-Loaded Triple-Mode Resonator with a Notched Band
An ultra-wide band band-pass filter using novel spiral stub-loaded triple-mode resonator (SSLTMR) is presented. New spiral stub loaded resonator is analyzed with odd and even modes analysis for this class of BPF, achieving higher band wide and size reduction. In order to have a good response characterized, two (SSL-TMRs) and two quarter wavelength digital coupled lines are used. This new design...
متن کاملFractal Bandpass Filter Using Y-shaped Dual-Mode Resonator for C-Band Receiver (Research Note)
In this study, a fractal, Y-shaped dual-mode resonator bandpass filter (BPF) with input-output cross-coupling is introduced. A parallel-coupling feed structure with a cross coupling has been used to generate two transmission zeroes (TZs) near the lower and upper cutoff frequency that can effectively improve the passband edge selectivity. Also, a fractal shaped based on conventional diamond and ...
متن کاملTunable Active Dual-Band Bandpass Filter Design Using MMIC Technology
Abstract— The inductor-less designing of monolithic tunable active dual-band bandpass filter is presented in this study. Biasing voltages signify main role. They can control the center frequency and quality factor. Using four biasing voltages and cascading two similar filters leads to dual-band bandpass filter. By keeping the gain constant, the center frequency shift is 200 MHz. Regardless cons...
متن کاملTriple Band Bandpass Filter Design and Implementation Using SIRs
Microstrip triple band tri-section bandpass filter using stepped impedance resonators (SIRs) is designed, simulated, built for the first time using hair pin structure and tested. The coupling effect between each SIR is investigated and its effect on the filter characteristics including bandwidth, attenuation is given. The simulation results, and measured results are compared and found to be ver...
متن کاملMicrostrip Dual-Band Bandpass Filter Using U-Shaped Resonators
Coupled resonators are widely used in the design of filters with dual-passband responses. In this paper, we present a dual-band bandpass filter using only couplings between adjacent resonators without cross-couplings. The dual-band bandpass filter with centre frequencies of 1747MHz and 1879MHz respectively is designed and fabricated using microstrip U-shaped resonators. Using the coupled resona...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics
سال: 2020
ISSN: 2079-9292
DOI: 10.3390/electronics9101633