Adhesion between thermoplastic elastomers and polyamide‐12 with different glass fiber fractions in two‐component injection molding
نویسندگان
چکیده
منابع مشابه
Injection Molding Micro- and Nanostructures in Thermoplastic Elastomers
Amongst the ever-growing toolbox of microand nanofabrication techniques, polymer replication-based processes continue to attract attention due to the conceptual simplicity, reproducibility, and great variety of often cheap materials that can be used. Cost and time saving advantages are further provided by high throughput replication techniques such as roll-to-roll nanoimprint lithography [ 1 ]
متن کاملSimulation of Orientation in Injection Molding of a Highly Concentrated, Short Glass Fiber Thermoplastic Composites
This paper presents a 2D coupled Hele-Shaw flow approximation for predicting the flow-induced orientation of injection molded composite parts within a commercial concentration range. For a highly concentrated short glass fiber PBT suspension, the impact of inter-particle interactions and the orientation at the gate is investigated for a center-gated disk using a time-delayed orientation evoluti...
متن کاملImprovements in the Simulation of Orientation in Injection Molding of Short Fiber Thermoplastic Composites
The mechanical properties of injection molded short-fiber reinforced thermoplastic composite parts are highly dependent on the orientation distribution of the fibers. A simulation tool capable of predicting fiber orientation accurately as a function of mold design and processing conditions is required as the predicted fiber orientation capabilities in commercial software show large discrepancie...
متن کاملFiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملThermoplastic Elastomers with Photo-actuating Properties
This contribution reviews elastomeric materials with photo-actuation behavior with emphasis on thermoplastic elastomers and their composites. The principles of the photo-actuation and the main factors affecting the photo-actuation phenomena of thermoplastic elastomer materials are discussed in detail. The well-performing photoactuating systems involving both statistical and block copolymers-bas...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Engineering & Science
سال: 2020
ISSN: 0032-3888,1548-2634
DOI: 10.1002/pen.25408