An Experimental Study on Milling Titanium Alloy with a Revolving Cycloid Milling Cutter

Experimental Study on Milling CFRP with Staggered PCD Cutter

Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the c...

Influence of Milling Conditions on the Surface Quality in High-Speed Milling of Titanium Alloy

The study was focused on the machined surface quality of titanium alloy under different milling conditions, including milling speed, tool rake angle and cooling method. The surface quality was investigated in terms of residual stress and surface roughness. The results show that the compressive residual stresses are generated on the machined surface under all milling conditions. The compressive ...

Study of the effective cutter radius for end milling of free-form surfaces using a torus milling cutter

Cryogenic Milling of Titanium Powder

Ti Grade 2 was prepared by cryogenic attritor milling in liquid nitrogen and liquid argon. Two types of milling balls were used—stainless steel balls and heavy tungsten carbide balls. The effect of processing parameters on particle size and morphology, contamination of powder and its microhardness was investigated. Milling in liquid nitrogen was not feasible due to excessive contamination by ni...

A Geometric Algorithm for Finding the Largest Milling Cutter

In this paper, we describe a new geometric algorithm to determine the largest feasible cutter size for 2-D milling operations to be performed using a single cutter. In particular: 1. We give a general definition of the problem as the task of covering a target region without interfering with an obstruction region. This definition encompasses the task of milling a general 2-D profile that include...