Analysis of dynamic stall development on a cross-flow turbine blade
نویسندگان
چکیده
This research analyzes the dynamic stall progression in cross-flow turbine blades demonstrating effects of flow curvature and induced caused by 360 degree rotation along an axis perpendicular to freestream. knowledge contributes low-order modeling through a proper orthogonal decomposition velocity fields, also explores alternative control strategy intracycle variation rate that modifies properties enhances power conversion efficiency.
منابع مشابه
Analysis of the Fracture of a Turbine Blade
The cause of crack initiation turbine blade had initially cracked by a fatigue mechanism over a period of time and then fractured by the overload at the last moment. Experimental procedure consists of macroscopic inspection, material verification, microscopic examination, and metallographic analysis and finally FE. And for these procedures, some specimens were prepared from a fractured blade. Us...
متن کاملDynamic Response of Flexible Wind Turbine Blade
Aiming at the non-stationary and stall flutter problems of wind turbine blade caused by transient load fluctuations, the dynamic properties of wind turbine were studied, the blade was simplify to a cantilever beam in case of the action of shear deformation and cross section rotating effect were considered in this analysis, equations of the blade were established based on D'Alemberts' principle ...
متن کاملTurbine Blade Tip Leakage Flow Control: Thick/Thin Blade Effects
An experiment was conducted in a linear cascade of Pak-B blades for an exit Mach number of 0.3 to simulate the flow in the tip-gap region of a low pressure turbine blade row. The experiment focused on the independent effects of thickness-to-gap and gapto-chord ratios on the tip-gap flow behavior. Two extreme gap-to-chord ratios of 5% and 8% were chosen, for which four thickness-to-gap ratios we...
متن کاملVibration analysis of a steam turbine blade
ABSTRACT Blade failure is a common problem of a steam turbine and it’s failure in-service results in safety risks, repair cost and non operational revenue losses. Thus, the reliability of these blades is very important for the successful operation of a steam turbine. Dynamic analysis of a steam turbine blade in computational environment is carried out in the present work. In order to gain physi...
متن کاملNumerical Simulation of Dynamic Stall Phenomena in Axial Flow Compressor Blade Rows
This article explores the simulation of stall phenomena in axial compressor blade rows. The approach is based on the numerical solution of the compressible, two-dimensional Navier-Stokes equations. The results of both unforced and forced low-speed rotor stall are presented. In unforced cases, substantial ow separation is observed before the maximum pressure rise operating point is reached. Thes...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical review fluids
سال: 2023
ISSN: ['2469-9918', '2469-990X']
DOI: https://doi.org/10.1103/physrevfluids.8.074702