ANALYSIS OF SURFACE ROUGHNESS ON MACHINING OF AL-5CU ALLOY IN CNC LATHE MACHINE
نویسندگان
چکیده
منابع مشابه
Analysis of Surface Roughness on Machining of Al-5cu Alloy in Cnc Lathe Machine
In this study, an experimental approach is presented for the measurement of the surface roughness of the machined surface produced by simple turning operation in a computer numerically controlled (CNC) Lathe. The parameters used in the experiment were reduced to three cutting parameters, cutting speed, depth of cut, feed rate. Other parameters such as tool nose radius, workpiece length, workpie...
متن کاملRuled Surface Machining on Five-Axis CNC Machine Tools
To achieve high precision and high productivity in machining sculptured surfaces, a new architecture for a five-axis CNC interpolator for machining ruled surfaces was developed and demonstrated on a milling machine. The objective of the five-axis interpolator is to continuously maintain the milling cutter axis in parallel with the straight lines of the ruled surface. The cutter position and ori...
متن کاملExperimental Investigation of Surface Roughness and Kerf Width During Machining of Blanking Die Material on Wire Electric Discharge Machine
Wire electric discharge machine (WEDM) is spark erosion in unconventional machining technique to cut hard and the conductive material with a wire as an electrode. The blanking die material SKD 11 is a high carbon and high chromium tool steel with high hardness and high wearing resistance property. This tool steel has broad application in press tools and dies making industries. In this research ...
متن کاملinvestigation of machining parameters effect on surface roughness in milling with hexapod machine tool
0
متن کاملAnalysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2013
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2013.0209044