Bandwidth Enhancement of Single-Layer Microstrip Reflectarrays with Multi-Dipole Elements
نویسندگان
چکیده
منابع مشابه
Single layer printed reflectarrays at MM-Waves
This paper talks about a method of conception and design constraints on mm-wave reflectarrays. The developed tool allows us to plan quickly the behavior of large reflectarray (several tens of wavelength) according to parameters as illumination law or manufacturing tolerance with good agreement with measurements. An ultra-low side-lobe reflectarrays of 130 mm diameter is designed. The structure ...
متن کاملDual-band Reflectarrays Using Microstrip Ring Elements and Their Applications with Various Feeding Arrangements
Dual-Band Reflectarrays Using Microstrip Ring Elements and Their Applications with Various Feeding Arrangements. (August 2006) Chul Min Han, B.S., Korea University Chair of Advisory Committee: Dr. Kai Chang In recent years there has been a growing demand for reduced mass, small launch volume, and, at the same time, high-gain large-aperture antenna systems in modern space-borne applications. Thi...
متن کاملNonsingular Green’s Functions for Multi-Layer Homogeneous Microstrip Lines
In this article, three new green's functions are presented for a narrow strip line (not a thin wire) inside or on a homogeneous dielectric, supposing quasi-TEM dominant mode. These functions have no singularity in contrast to so far presented ones, so that they can be used easily to determine the capacitance matrix of multi-layer and single-layer homogeneous coupled microstrip lines. To obtain ...
متن کاملEnhancement of Bandwidth in Microstrip Patch Antenna using EBG
This paper presents the bandwidth and gain enhancement of microstrip patch antenna using EBG for X band (10 Ghz) application. The surface waves must be suppressed to increase the bandwidth and gain by using EBG. By using EBG the stop band characteristics is created over certain frequency and that has been adapted to suppress the surface wave and to enhance the gain and bandwidth of the antenna ...
متن کاملAnalysis and Design of Passive and Active Microstrip Reflectarrays
The design of reflectarrays is a complex and time-consuming process that very often relies on a trial-and-error approach. In this article, a simplified analysis based on a commercial simulator is proposed. This method, valid for both passive and active antennas, uses a simulator to characterize the single radiating cell and evaluates the contribution of the finite ground plane using physical op...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electromagnetic Engineering and Science
سال: 2019
ISSN: 2234-8409,2234-8395
DOI: 10.26866/jees.2019.19.2.130