Characterization of calcium carbonates used in wet flue gas desulphurization processes
نویسندگان
چکیده
منابع مشابه
Dynamics of wet flue gas desulphurization in spray absorber
A concise one dimensional thermal-hydraulic two-fluid model is presented for the numerical prediction of sulphur dioxide absorption from the flue gas onto drops of the water-limestone slurry in the vertical spray tower absorber. The model is based on mass, momentum and energy balance equations for each phase separately, i.e. downward falling droplets of water-limestone slurry and upward flowing...
متن کاملInvestigation of Parameters Affecting Gypsum Dewatering Properties in a Wet Flue Gas Desulphurization Pilot Plant
Wet flue gas desulphurization (FGD) plants with forced oxidation, installed at coal and oil fired power plants for removal of SO2(g), must produce gypsum of high quality. However, quality issues such as an excessive moisture content, due to poor gypsum dewatering properties, may occur from time to time. In this work, the particle size distribution, morphology, and filtration rate of wet FGD gyp...
متن کاملMicrobial communities associated with wet flue gas desulfurization systems
Flue gas desulfurization (FGD) systems are employed to remove SO(x) gasses that are produced by the combustion of coal for electric power generation, and consequently limit acid rain associated with these activities. Wet FGDs represent a physicochemically extreme environment due to the high operating temperatures and total dissolved solids (TDS) of fluids in the interior of the FGD units. Despi...
متن کاملFlue Gas Conditioning
Flue gas conditioning (FGC) systems offer an effective option for control of Particulate Matter (PM) emissions and enhances the performance of the Electrostatic Precipitators (EPs) when using coal of different properties. The increasing environmental awareness and the mandate of the Environmental Protection Agencies (EPA) in various countries to thermal power stations using coal-fired boilers f...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Open Chemistry
سال: 2012
ISSN: 2391-5420
DOI: 10.2478/s11532-012-0068-4