Cold Spray Deposition of Ni and WC-Reinforced Ni Matrix Composite Coatings
نویسندگان
چکیده
منابع مشابه
Electroless Ni–P composite coatings
This review outlines the development of electroless Ni–P composite coatings. It highlights the method of formation, mechanism of particle incorporation, factors influencing particle incorporation, effect of particle incorporation on the structure, hardness, friction, wear and abrasion resistance, corrosion resistance, high temperature oxidation resistance of electroless Ni–P composite coatings ...
متن کاملEffect of WC Concentration on Abrasive Wear Properties of the Thermally Sprayed WC -Ni Coatings
In this work the effects of WC concentration on abrasive wear behavior by thermally sprayed WC coating was evaluated using three body abrasive wear tester. A different combination of WC and NI coatings were deposited on steel substrates by flame spraying using powder with different WC concentrations (0 %, 12.5 %, 25 %, and 50 %). Flame torch was used for heating and coating of process. Microstr...
متن کاملFabrication of TiC particulate reinforced Ni-50Fe super alloy matrix composite powder by mechanical alloying
Mechanical alloying is a powder metallurgy processing technique involving cold welding, fracturing, and rewelding of powder particles in a high-energy ball mill. In this work, NiFe-TiC composite powders were prepared by mechanical alloying process using planetary high-energy ball mill. The effect of TiC addition by weight percent on the NiFe solid solution formation, grain size, lattice paramet...
متن کاملDevelopment of Corrosion Resistant Zn-Ni-TiO2 Composite Coatings
The Zn-Ni-TiO2 composite coatings were developed on mild steel by electrodeposition method. The bath constituents (ZnSO4.6H2O, NiSO4.6H2O, TiO2, thiamine hydrochloride) and operating conditions (temperature and pH) were optimized by Hull cell method, for peak performance of the coating against corrosion. The coatings were prepare...
متن کاملElectrodeposited Co – Ni – Al O composite coatings 2 3
Composite coatings of Co–Ni–Al O were studied by electrolytic codeposition of Co–Ni alloys and Al O from a sulfamate 2 3 2 3 electrolyte containing Al O particles. The influence of plating parameters on the content of the co-deposited Al O particles in 2 3 2 3 Co–Ni alloys was investigated. The maximum value of co-deposited Al O can be achieved at a particle content of 80 g l in y1 2 3 bath, a ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Thermal Spray Technology
سال: 2017
ISSN: 1059-9630,1544-1016
DOI: 10.1007/s11666-017-0636-4