Computational investigation of liquid-solid slurry flow through an expansion in a rectangular duct
نویسندگان
چکیده
منابع مشابه
Fluid flow and heat transfer characteristics in a curved rectangular duct using Al2O3-water nanofluid
In the present research, the laminar forced convective heat transfer and fluid flow characteristics for Al2O3-water nanofluid flowing in different bend (i.e., 180o and 90o) pipes have been investigated numerically in a three-dimensional computational domain using the finite volume technique. The effects of different pertinent parameters, such as the Reynolds number of the duct, volume fraction ...
متن کاملan investigation of the types of text reduction in subtitling: a case study of the persian film gilaneh with english subtitles
چکیده ندارد.
15 صفحه اولNumerical Investigation of flow through Annular Diffusing Duct
In the present investigation the distribution of mean velocity, static pressure and total pressure are experimentally studied on an annular curved diffuser of 37.5° angle of turn with an area ratio of 1.273 at Reynolds number 1.85 x 10 based on inlet diameter and mass average inlet velocity. The experimental results then were numerically validated with the help of Fluent and then a series of pa...
متن کاملExperimental and Computational Investigation of Flow Development and Pressure Drop in a Rectangular Micro-channel
Flow development and pressure drop were investigated both experimentally and computationally for adiabatic single-phase water flow in a single 222 m wide, 694 m deep, and 12 cm long rectangular micro-channel at Reynolds numbers ranging from 196 to 2215. The velocity field was measured using a micro-particle image velocimetry system. A three-dimensional computational model was constructed which ...
متن کاملNumerical Simulation of Turbulent Subsonic Compressible Flow through Rectangular Microchannel
In this study, turbulent compressible gas flow in a rectangular micro-channel is numerically investigated. The gas flow assumed to be in the subsonic regime up to Mach number about 0.7. Five low and high Reynolds number RANS turbulence models are used for modeling the turbulent flow. Two types of mesh are generated depending on the employed turbulence model. The computations are performed for R...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Hydrology and Hydromechanics
سال: 2014
ISSN: 0042-790X
DOI: 10.2478/johh-2014-0021