Corrosion of Tungsten Carbide in Aqueous Alkaline Solutions Containing Dissolved Air
نویسندگان
چکیده
منابع مشابه
Comparison of Dissolved Air Flotation Process for Aniline and Penicillin G Removal From Aqueous Solutions
Introduction: The presence of antibiotics due to toxicity and sustainability as well as organic compounds as a combination of hard biodegradable wastewater is an undesirable issue in many industries. The aim of this study was to evaluate the efficiency of dissolved air flotation process for aniline and penicillin G removal from aqueous solutions. Methods: This was an empirical-lab study to w...
متن کاملCarbide formation in tungsten-containing amorphous carbon films by annealing
Tungsten-containing amorphous carbon films were produced by dual magnetron sputter deposition. The formation of carbide phases after heat treatment in inert gas at temperatures up to 2800 K was investigated by X-ray diffraction for tungsten concentrations below 25 at%. After deposition, each film consists of an amorphous carbon matrix with atomically dispersed W inclusions. Annealing up to 2800...
متن کاملPhotoionization of Indole in Alkaline Aqueous Solutions
The photoionization process of indole in alkaline aqueous solutions at 77 °K and the recombination process of trapped electron with its mother molecule were investigated. The fluorescence spectrum of indole in these glassy media depended on the NaOH concentration; the disappearance of the 325 nm band at the NaOH concentrations higher than 5 M with the appearance of a fluorescence band at 375 nm...
متن کاملGalvanic Corrosion between Alloy 690 and Magnetite in Alkaline Aqueous Solutions
The galvanic corrosion behavior of Alloy 690 coupled with magnetite has been investigated in an alkaline solution at 30 °C and 60 °C using a potentiodynamic polarization method and a zero resistance ammeter. The positive current values were recorded in the galvanic couple and the corrosion potential of Alloy 690 was relatively lower. These results indicate that Alloy 690 behaves as the anode of...
متن کاملTHE ROLE OF ALKALINE CLEANING SOLUTIONS AND CL-CONTAINING LUBRICANTS ON PITTING CORROSION IN NiTi ALLOYS
Alkaline cleaning agents are found to react with remnant manufacturing lubricants trapped in surface defects of a NiTi alloy to form Cl-based salts. These sub-surface “reservoirs” may act as nucleation sites for pitting corrosion either latent under ambient conditions, or on exposure to a limited range of high temperatures used to impart pseudoelastic properties in these alloys as part of norma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Denki Kagaku oyobi Kogyo Butsuri Kagaku
سال: 1974
ISSN: 0366-9297,2434-2556
DOI: 10.5796/kogyobutsurikagaku.42.178