Cutting Forces and 3D Surface Analysis of CFRP Milling with PCD Cutting Tools
نویسندگان
چکیده
منابع مشابه
Experimental Study on Milling CFRP with Staggered PCD Cutter
Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the c...
متن کاملInvestigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملAnalytical Cutting Forces Model of Helical Milling Operations
Helical milling operations are used to generate or enlarge boreholes by means of a milling tool. The bore diameter can be adjusted through the diameter of the helical path. The kinematics of helical milling on a three axis machine tool is analysed firstly. The relationships between processing parameters, cutting tool geometry characters with machined hole feature are formulated. The feed motion...
متن کاملExperimental Measurement of NC Machine Tool Milling Cutting Forces
Experimental measurement of the cutting forces in milling processes can be a useful tool to validate standard and non-conventional milling models to be adopted in most industrial applications. As an example, such models can be used to design the machine tool components and fixtures, to choose the technological process parameters and to define process monitoring and diagnostic tools such as moni...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2016
ISSN: 2212-8271
DOI: 10.1016/j.procir.2016.03.091