Cutting Forces Calculation and Experimental Measurement for 5-axis Ball End Milling
نویسندگان
چکیده
منابع مشابه
Experimental Measurement of NC Machine Tool Milling Cutting Forces
Experimental measurement of the cutting forces in milling processes can be a useful tool to validate standard and non-conventional milling models to be adopted in most industrial applications. As an example, such models can be used to design the machine tool components and fixtures, to choose the technological process parameters and to define process monitoring and diagnostic tools such as moni...
متن کاملAn Instantaneous Rigid Force Model For 3-Axis Ball-End Milling Of Sculptured Surfaces
An instantaneous rigid force model for prediction of cutting forces in ball-end milling of sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملPrediction of Chatter in CNC Machining based on Dynamic Cutting Force for Ball End Milling
This paper presents the suitable depth of cut, spindle speed and feed rate that will be chosen during machining. If thus parameters are not considered, this can provoke abnormal tool behavior such as chatter. Chatter will limit the tool life which only can be use for just a few times. To predict the chatter occurs, the parameters will be use are spindle speed, depth of cut and feed rate. CNC ma...
متن کاملDiscrete Cutting Force Model for 5-Axis Milling with Arbitrary Engagement and Feed Direction
5-axis machining operations bring new challenges for predicting cutting forces. Complex tool workpiece engagements and tool orientations make it difficult to adapt 3-axis process models for 5-axis operations. A new model is developed to predict cutting forces with arbitrary tool/workpiece engagement and tool feed direction. A discretization approach is used, in which the tool is composed of mul...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2013
ISSN: 2212-8271
DOI: 10.1016/j.procir.2013.06.095