Cylinder Pressure-Based Spark Advance Control for SI Engines.
نویسندگان
چکیده
منابع مشابه
Cylinder Pressure and Ionization Current Modeling for Spark Ignited Engines
Engine management systems (EMS) need feedback on combustion performance to optimally control internal combustion engines. Ion sensing is one of the cheapest and most simple methods for monitoring the combustion event in a spark ignited engine, but still the physical processes behind the formation of the ionization current are not fully understood. The goal here is to investigate models for ioni...
متن کاملCylinder pressure based combustion phase optimization and control in spark-ignited engines
Efficiency and emissions of spark-ignited engines are significantly affected by combustion phase which can usually be indicated by crank angle of 50% mass burnt (CA50). Managing combustion phase at the optimal value at which the maximal efficiency can be achieved is a challenging issue due to the cyclic variations of combustion process. This paper addresses this issue in two loops: CA50 set-poi...
متن کاملSpark Advance Modeling and Control
The spark advance determines the efficiency of spark-ignited (SI) engines by positioning the combustion in relation to the piston motion. Today’s spark-advance controllers are open-loop systems that measure parameters that effect the sparkadvance setting and compensate for their effects. Several parameters influence the best spark-advance setting but it would be too expensive to measure and acc...
متن کاملOptimization-based non-linear Control Law with Increased Robustness for Air Fuel Ratio Control in SI Engines
In spark ignition (SI) engines, the accurate control of air fuel ratio (AFR) in the stoichiometric value is required to reduce emission and fuel consumption. The wide operating range, the inherent nonlinearities and the modeling uncertainties of the engine system are the main difficulties arising in the design of AFR controller. In this paper, an optimization-based nonlinear control law is a...
متن کاملIndividual Air-Fuel Ratio Balancing Control for Multi-Cylinder SI Engines: Modeling and Validation
The three phase catalyst is popularly employed in modern engines for exhaust control and its catalytic efficiency is determined by the Air-Fuel ratio (A/F). In this paper, individual A/F control problem is addressed for a multi-cylinder SI engine, of which one exhaust pipe is shared by many cylinders. Firstly, an overlap model to describe the dynamics from individual fuel injection to A/F value...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series B
سال: 2001
ISSN: 1340-8054,1347-5371
DOI: 10.1299/jsmeb.44.305