Design of a 900 MHz Band Wake-Up Receiver with −52 dBm Sensitivity
نویسندگان
چکیده
منابع مشابه
An 868 MHz 7 . 5 μ W wake - up receiver with − 60 dBm sensitivity
In wireless sensor networks (WSNs), batteries are unlikely to be replaced or recharged once they get depleted, because of costs and feasibility. In a typical application, sensor nodes should be accessible and able to respond within a defined period of time, especially in real-time applications. However, the idle listening of the radio wastes most of the energy since the radio transceiver is con...
متن کامل. 2 A 2 GHz 52 μ W Wake - Up Receiver with - 72 dBm
A wake-up receiver (WuRx) is used in wireless sensor networks (WSN) to detect wireless traffic directed to a node’s receiver and activate it upon detection, improving network latency and energy dissipation by maximizing data transceiver sleep time. The always-on nature of the WuRx sets a power dissipation floor for the entire system. In realistic WSN scenarios, the adoption of a WuRx leads to e...
متن کاملA Tuned-RF Duty-Cycled Wake-Up Receiver with −90 dBm Sensitivity
A novel wake-up receiver for wireless sensor networks is introduced. It operates with a modified medium access protocol (MAC), allowing low-energy consumption and practical latency. The ultra-low-power wake-up receiver operates with enhanced duty-cycled listening. The analysis of energy models of the duty-cycle-based communication is presented. All the WuRx blocks are studied to obey the duty-c...
متن کاملA 2.4/5.8 GHz 10 μW Wake-Up Receiver With -65/-50 dBm Sensitivity Using Direct Active RF Detection
This paper presents a fully integrated wake-up receiver (WuRx) with direct active RF detection. The RF front-end features a high-sensitivity RF detector embedded with input matching network, obviating the need of RF amplification and LO generation for frequency downconversion. This complete receiver contains an RF detector, IF amplifiers, and a continuous-time ΣΔ ADC to provide inherent anti-al...
متن کاملDC-Coupled IF Stage Design for a 900-MHz ISM Receiver
This paper presents a dc-coupled 900-MHz ISM band RF front-end for a short-range wireless receiver. The front-end, fabricated in a 0.5m CMOS process, is intended as a test vehicle to verify the proposed dc-coupled topology. In this topology, a lowfrequency feedback circuit suppresses the dc offset and low-frequency noise at the mixer output. The dc-coupled topology is compared with traditional ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2021
ISSN: 1226-3133,2288-226X
DOI: 10.5515/kjkiees.2021.32.3.243