Design of Low Noise Amplifier for WLAN using pHEMT
نویسندگان
چکیده
منابع مشابه
Design and Fabrication of a 911 GHz Balanced Low Noise Amplifier Using HJFET
This paper describes the design of an X-band balanced low noise amplifier (LNA) using an available HJFET device. The balanced LNA consists of a pair of electrically similar transistors whose input and output signals are divided or combined by 3 dB two-stage Wilkinson power dividers. The proposed balanced LNA is fabricated and measured. The measured results show that the noise figure is 1.30 dB ...
متن کاملRf Low Noise Amplifier for Ieee Standard 802.11a Wlan
Low noise amplifier is the front end block of radio-frequency receiver system. Its design required various characteristics such as power gain, noise figure, insertion losses and power consumption. In this paper we have proposed a single stage low noise amplifier design with high gain and low noise using inductive source degeneration topology for frequency range of 3 GHz to 7 GHz and also use th...
متن کاملA Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers
In this paper, a new design of concurrent dual-band Low Noise Amplifier (LNA) for multi-band single-channel Global Navigation Satellite System (GNSS) receivers is proposed. This new structure is able to operate concurrently at frequency of 1.2 and 1.57 GHz. Parallel and series resonance parts are employed in the input matching in order to achieve concurrent performance. With respect to used pse...
متن کاملA 3-6 GHz Current Reused Noise Canceling Low Noise Amplifier for WLAN and WPAN Applications
ISSN: 2347-8578 www.ijcstjournal.org Page 315 A 3-6 Ghz Current Reuse Noise Cancelling Low Noise Amplifier For WLAN And WPAN Application Shivabhakt Mhalasakant Hanamant [1], Dr.S.D.Shirbahadurakar [2] M.E Student , Guide [2] Department of E & TC Dr. D.Y.Patil COE, Ambi Pune – India ABSTRACT A wideband low-noise amplifier (LNA), which is a key block in the design of broadband receivers for multi...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering & Technology
سال: 2020
ISSN: 2227-524X
DOI: 10.14419/ijet.v9i2.30051