Development of a Piezoelectric Transducer-Based Integrated Structural Health Monitoring System for Impact Monitoring and Impedance Measurement
نویسندگان
چکیده
منابع مشابه
Structural health monitoring using piezoelectric impedance measurements.
This paper presents an overview and recent advances in impedance-based structural health monitoring. The basic principle behind this technique is to apply high-frequency structural excitations (typically greater than 30kHz) through surface-bonded piezoelectric transducers, and measure the impedance of structures by monitoring the current and voltage applied to the piezoelectric transducers. Cha...
متن کاملImpedance-based Structural Health Monitoring
1. Introduction The development of a real-time, in-service structural health monitoring and damage detection technique has recently attracted a large number of academic and industrial researchers. The goal of this research is to allow systems and structures to monitor their own integrity while in operation and throughout their lives in order to prevent catastrophic failures and to reduce the co...
متن کاملFinite-dimensional piezoelectric transducer modeling for guided wave based structural health monitoring
Among the various schemes being considered for structural health monitoring (SHM), guided wave (GW) testing in particular has shown great promise. While GW testing using hand-held transducers for non-destructive evaluation (NDE) is a well established technology, GW testing for SHM using surface-bonded/embedded piezoelectric wafer transducers (piezos) is relatively in its formative years. Little...
متن کاملThermo-Electro Mechanical Impedance based Structural Health Monitoring: Euler- Bernoulli Beam Modeling
In recent years, impedance measurement method by piezoelectric (PZT) wafer activesensor (PWAS) has been widely adopted for non-destructive evaluation (NDE). In this method, theelectrical impedance of a bonded PWAS is used to detect a structural defect. The electro-mechanicalcoupling of PZT materials constructs the original principle of this method. Accordingly, the electricalimpedance of PWAS c...
متن کاملNanowire Based Flexible Piezoelectric Sensor for Structural Health Monitoring Applications
Gallium nitride (GaN) wires are used to build up capacitive flexible piezoelectric sensors dedicated to structural health monitoring applications. These slightly cone-shaped nanowires with a hexagonal cross section are grown on sapphire substrate by Metal Organic Vapor Phase Epitaxy (MOVPE); their length (L) can vary from few microns up to hundreds of microns, while the conicity angle (alpha) e...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Sciences
سال: 2020
ISSN: 2076-3417
DOI: 10.3390/app10062062