Development of aluminum alloy vabve lifter for high performance engine.
نویسندگان
چکیده
منابع مشابه
Cast Aluminum Alloy for High Temperature Applications
Originally developed by NASA as high performance piston alloys to meet U.S. automotive legislation requiring low exhaust emission, the novel NASA alloys now offer dramatic increase in tensile strength for many other applications at elevated temperatures from 450°F (232°C) to about 750°F (400°C). It is an ideal low cost material for cast automotive components such as pistons, cylinder heads, cyl...
متن کاملEvaluation of continuum damage at different temperatures for aluminum-silicon alloy of engine piston within low-cycle fatigue regime
In this article, the isothermal low-cycle fatigue continuum damage in the engine piston aluminum alloy has been evaluated at different temperatures. For this objective, experimental data of low-cycle fatigue tests on standard specimens were used at 280, 350 and 425°C. Based on the continuum damage mechanics method, the fatigue damage was calculated during cyclic loading. Obtained results, inclu...
متن کاملEvaluating the coupled thermo-mechanical stresses for an aluminum alloy piston used in a gasoline engine XU7
In modern engines with higher compression ratios, severe pressures and non-uniform heating up is occurred for the engine parts. The piston as the most critical part among all automotive components has been the subject of numerous studies on calculation of temperature distribution, but thermal stress analyses are limited. In this study, the piston of gasoline engine XU7 which is widespread in Ir...
متن کاملTexture Measurement in Aluminum Alloy at High Temperature
The casting and hot rolling process is a most important and widely used industrial route to produce aluminum alloy sheet[I]. Because rolling is such a high volume process and the capital expenditure in plants and fabrication facilities is so large, even small cost savings or increases in efficiency can result in a very large total money savings[2, 3]. To remove the very costly and time-consumin...
متن کاملassessment of the park- ang damage index for performance levels of rc moment resisting frames
چکیده هدف اصلی از طراحی لرزه ای تامین ایمنی جانی در هنگام وقوع زلزله و تعمیر پذیر بودن سازه خسارت دیده، پس از وقوع زلزله است. تجربه زلزله های اخیر نشان داده است که ساختمان های طراحی شده با آیین نامه های مبتنی بر نیرو از نظر محدود نمودن خسارت وارده بر سازه دقت لازم را ندارند. این امر سبب پیدایش نسل جدید آیین نامه های مبتنی بر عملکرد شده است. در این آیین نامه ها بر اساس تغییرشکل های غیرارتجاعی ...
15 صفحه اولذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Japan Institute of Metals
سال: 1990
ISSN: 0021-4426,1884-5835
DOI: 10.2320/materia1962.29.250