Development of Direct Reactive Extrusion and Molding System
نویسندگان
چکیده
منابع مشابه
Neural Modeling of Parison Extrusion in Extrusion Blow Molding
Back-propagation (BP) neural network is used to develop process models for the parison extrusion in extrusion blow molding based on experimental data. In applying the BP network, some modifications, such as using a self-adaptive learning rate coefficient, determining the number of hidden neurons through experimentation, and so on, to the original BP algorithm are carried out to speed up learnin...
متن کاملDevelopment of an Intelligent Cavity Layout Design System for Injection Molding Dies (RESEARCH NOTE)
This paper presents the development of an Intelligent Cavity Layout Design System (ICLDS) for multiple cavity injection moulds. The system is intended to assist mould designers in cavity layout design at concept design stage. The complexities and principles of cavity layout design as well as various dependencies in injection mould design are introduced. The knowledge in cavity layout design is ...
متن کاملthe survey of the virtual higher education in iran and the ways of its development and improvement
این پژوهش با هدف "بررسی وضعیت موجود آموزش عالی مجازی در ایران و راههای توسعه و ارتقای آن " و با روش توصیفی-تحلیلی و پیمایشی صورت پذیرفته است. بررسی اسنادو مدارک موجود در زمینه آموزش مجازی نشان داد تعداد دانشجویان و مقاطع تحصیلی و رشته محل های دوره های الکترونیکی چندان مطلوب نبوده و از نظر کیفی نیز وضعیت شاخص خدمات آموزشی اساتید و وضعیت شبکه اینترنت در محیط آموزش مجازی نامطلوب است.
Direct Adaptive Control of Resin Transfer Molding
Resin Transfer Molding (RTM) is a manufacturing process that involves injection of liquid resin into a closed mold cavity containing preset fiber mats and a subsequent curing stage. Mold filling is a crucial stage for quality part productions. In order to automate production and minimize the formation of defects, control of mold filling is needed. In this paper, direct adaptive control strategy...
متن کاملChemical Modification of Polysaccharides Using Reactive Extrusion
Sodium carboxymethyl starch (CMS) was prepared using an extruder as a continuous solvent-less chemical reactor. The effects of NaOH, H2O, temperature, ethanol, sodium mono chloro acetate (SMCA), sodium tripolyphosphate (STPP), citric acid, epichlorohydrin and screw configuration on the degree of substitution (DS) and swelling properties of CMS were studied. Using these factors, CMS with the DS ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 1992
ISSN: 1883-7417,0915-4027
DOI: 10.4325/seikeikakou.4.484