Durability of Sprayed WC/Co Coatings in Al-added Zinc Bath.
نویسندگان
چکیده
منابع مشابه
Solid Particle Erosion of Thermal Sprayed Coatings
Solid particle erosion is an important material degradation mechanism. Although various methods of coating are tried and used for protection against erosion, thermal sprayed coating for such purpose is the most widely used method. In this chapter, evolution of thermal sprayed coating, erosion testing methods, and erosive wear of thermal sprayed coatings are discussed extensively with emphasis o...
متن کاملA Review on Detonation Gun Sprayed Coatings
Materials are precious resources. Different methods are employed to protect the material from degradation. Thermal spraying is one of the most effective method to protect the material from wear, high temperature corrosion, stresses and erosion, thus increasing the life of material in use. Detonation gun spraying is one of the thermal spraying techniques known for providing hard, wear resistant ...
متن کاملSintering of Fine Particles in Suspension Plasma Sprayed Coatings
Suspension plasma spraying is a process that enables the production of finely grained nanometric or submicrometric coatings. The suspensions are formulated with the use of fine powder particles in water or alcohol with some additives. Subsequently, the suspension is injected into plasma jet and the liquid additives evaporate. The remaining fine solids are molten and subsequently agglomerate or ...
متن کاملEffect of Laser Remelting on Friction-Wear Behaviors of Cold Sprayed Al Coatings in 3.5% NaCl Solution
A cold sprayed Al coating on S355 structural steel was processed using a laser remelting (LR). The surface and cross-section morphologies, chemical compositions, and phases of as-obtained Al coating before and after LR were analyzed using a scanning electronic microscope (SEM), energy dispersive spectrometer (EDS), and X-ray diffractometer (XRD), respectively, and their hardness was measured us...
متن کاملAdhesion Strength Evaluation Methods in Thermally Sprayed Coatings
The techniques for estimating the adhesive and cohesive strength in high velocity oxy fuel (HVOF) thermal spray coatings have been discussed and compared. The development trend and the last investigation have been studied. We will focus on benefits and limitations of these methods in different process and materials. Keywords—Adhesion, Bonding strength, Cohesion, HVOF Thermal spray
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 1994
ISSN: 0915-1559
DOI: 10.2355/isijinternational.34.822