Dynamic power efficiency improvement for PWM class-D amplifier
نویسندگان
چکیده
منابع مشابه
Dynamic power efficiency improvement for PWM class-D amplifier
This paper presents the technique to dynamically enhance the power efficiency of PWM class-D amplifier over a wide range of modulation indexes. The power stage of amplifier is segmented into several small stages and selectively enabled according to the power demand (i.e. modulation indexes). The capability of power delivery is dynamically adjusted to minimize the power loss in case of different...
متن کاملDynamic Bias Circuits for Efficiency Improvement of RF Power Amplifier
This work presents a dynamic gate bias circuit for bias control to maximize power added efficiency based on the class-A two-stage power amplifier. The proposed circuits are composed of two NMOS transistors, a capacitor for coupling RF input signal, and four resistors for bias. The circuit is implemented by means of the bias control at the two-stage power amplifier to improve the overall power a...
متن کاملClass D Power Amplifier for Medical Application
The objective of this research was to design a 2.4 GHz class AB Power Amplifier (PA), with 0.18um Semiconductor Manufacturing International Corporation (SMIC) CMOS technology by using Cadence software, for health care applications. The ultimate goal for such application is to minimize the trade-offs between performance and cost, and between performance and low power consumption design. This pap...
متن کاملHigh Efficiency Class-F Power Amplifier Design
Due to the high increase in and demand for a wide assortment of applications that require low-cost, high-efficiency, and compact systems, RF power amplifiers are considered the most critical design blocks and power consuming components in wireless communication, TV transmission, radar, and RF heating. Therefore, much research has been carried out in order to improve the performance of power amp...
متن کاملPulse Width Modulation for Class D Audio Power Amplifier with 85% of Efficiency
In this paper a high efficiency PWM CMOS audio power amplifier is proposed. The original idea is based on the difference close-loop feedback technique and the difference pre-amp. Thus, we conceive a rail to rail comparator with a constant gm. This rail-to-rail PWM comparator with hysteresis architecture has been embedded in the audio power amplifier. The simulation results based on the TSMC 0.1...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2013
ISSN: 1349-2543
DOI: 10.1587/elex.10.20130073