Electro-thermal measurements and finite element method simulations of a spark plasma sintering device
نویسندگان
چکیده
منابع مشابه
Spark Plasma Synthesis (SPS) Device for Sintering of Nanomaterials
It is known that work pieces with nanocrystalline structure condition have much higher performance than those with an ordinary structure. There are known number of techniques for manufacturing of nanocrystalline materials in powder condition however a question of manufacturing bulk pieces in the same nanocrystalline state mentioned is that compaction and synthesizing of nanocrystalline powders ...
متن کاملSimulation of thermal and electric field evolution during spark plasma sintering
Finite element simulations have been conducted to determine the temperature distribution (both in radial and axial direction), heat and electric flux-field in the powder compact/die/punch assembly during the spark plasma sintering (SPS) process. A thermal–electrical coupled model with temperature dependent thermal and electrical properties is implemented. The simulation studies were conducted u...
متن کاملSolid state sintering of very low and negative thermal expansion ceramics by Spark Plasma
Lithium aluminosilicate powder precursors of compositions Li2O:Al2O3:SiO2 as 1:1:2; and 1:1:3.11 were synthesized and sintered by the Spark Plasma Sintering technique. The sintering conditions were adjusted to obtain dense ceramic materials in an attempt to avoid the presence of a glassy phase. XRD and SEM images were employed for composition and microstructure characterization. The coefficient...
متن کاملChemical analysis of silica doped hydroxyapatite biomaterials consolidated by a spark plasma sintering method.
Silica (SiO(2)) and the silicate-based biomaterials play an important role due to their in vitro and in vivo biological response. The present study synthesized a novel nano-structured amorphous silica doped hydroxyapatite (HA) via an aqueous precipitation route. HA was prepared with 0, 1, 3 and 5 wt% silica, which are comparable to the measured silicon content of natural bone. After spray dryin...
متن کاملFabrication of Nanostructured Cu matrix Nanocomposites by High Energy Mechanical Milling and Spark Plasma Sintering
Spark plasma sintering (SPS) is a sintering process that is capable of sintering hard worked powders in short times. This technique was used to fabricate bulk Cu and Cu-SiC nanocomposites. Pure Cu and mixed powders of Cu including 4 vol% of SiC nanoparticles were mechanically alloyed for 25 h and sintered at 750˚C under vacuum condition by SPS method. Microstructures of the materials were chara...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Processing Technology
سال: 2013
ISSN: 0924-0136
DOI: 10.1016/j.jmatprotec.2013.02.003