Electronic properties of nanotube-based sensors: An inverse modeling approach
نویسندگان
چکیده
منابع مشابه
Electronic properties of nanotube-based sensors: An inverse modeling approach
Nanotube-based sensors depend on significant conductivity changes induced by doping. Predictions of which impurity/nanotube combination provides efficient sensor characteristics are usually made on a case-by-case basis, following the study of how a particular nanotube responds to the presence of a specific doping agent. With a multitude of possible combinations, this so-called forward modeling ...
متن کاملinvestigation of the electronic properties of carbon and iii-v nanotubes
boron nitride semiconducting zigzag swcnt, $b_{cb}$$n_{cn}$$c_{1-cb-cn}$, as a potential candidate for making nanoelectronic devices was examined. in contrast to the previous dft calculations, wherein just one boron and nitrogen doping configuration have been considered, here for the average over all possible configurations, density of states (dos) was calculated in terms of boron and nitrogen ...
15 صفحه اولCarbon nanotube-based ethanol sensors.
Sensors containing metal-carbon nanotube (CNT) hybrid materials as the active sensing layer were demonstrated for ethanol vapor detection at room temperature. The metal-CNT hybrid materials were synthesized by infiltrating single wall carbon nanotubes (SWNTs) with the transition metals Ti, Mn, Fe, Co, Ni, Pd or Pt. Each sensor was prepared by drop-casting dilute dispersions of a metal-CNT hybri...
متن کاملCarbon Nanotube-Based Chemiresistive Sensors
The development of simple and low-cost chemical sensors is critically important for improving human life. Many types of chemical sensors have been developed. Among them, the chemiresistive sensors receive particular attention because of their simple structure, the ease of high precise measurement and the low cost. This review mainly focuses on carbon nanotube (CNT)-based chemiresistive sensors....
متن کاملElectronic properties of carbon nanotube/fabric composites
Single walled carbon nanotube (SWNT)/fabric composite materials were manufactured using two simple manufacturing processes. The first method is direct deposition of SWNTs by either a spray method or by incubation; the other is a Quasi-Langmuir–Blodgett (QLB) transfer technique. The composite retains high mechanical strength (governed by the fabric), and good electrical properties (determined by...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: EPL (Europhysics Letters)
سال: 2008
ISSN: 0295-5075,1286-4854
DOI: 10.1209/0295-5075/82/27004