Experimental Investigation for Optimizing EDM Parameters for Die Steel D3 to analyze MRR, TWR and Radial Overcut
نویسندگان
چکیده
منابع مشابه
Application of Response Surface Methodology For Determining MRR and TWR Model In Die Sinking EDM of AISI 1045 Steel
Whereas the efficiency of traditional cutting processes is limited by the mechanical properties of the processed material and the complexity of the workpiece geometry, electrical discharge machining (EDM) being a thermal erosion process, is subject to no such constraints. The base material used for this study was an AISI 1045 steel with copper electrode. This study highlights the development of...
متن کاملExperimental Investigation of Wire-EDM Process Parameters on MRR of Ti-6al-4v Alloy
The objective of the present work was to investigate the effect of the wire electrical discharge machining process parameters on material removal rate of titanium alloy using Taguchi approach. A brass wire of 250μm was applied as a tool electrode to cut the specimen. L36 mixed orthogonal array (2 ×3) has been selected for experimentation under different variables like dielectric conductivity, p...
متن کاملInvestigation and Fuzzy Based Modeling of Micro-edm Process during Machining of Micro-hole in D3 Die Steel Material Employing De-ionized Water
The correct selection of process parameters for manufacturing is one of the most important aspects taken into consideration in the majority of manufacturing processes and particularly, in process related to EDM. The machining characteristics are greatly influenced by the nature of dielectric used during micro-EDM. The present paper investigates the fuzzy logic model for micro-electrical dischar...
متن کاملOptimization of Control Parameters for MRR in Injection Flushing Type of EDM on Stainless Steel 304 Workpiece
The operating control parameters of injection flushing type of electrical discharge machining process on stainless steel 304 workpiece with copper tools are being optimized according to its individual machining characteristic i.e. material removal rate (MRR). Lower MRR during EDM machining process may decrease its’ machining productivity. Hence, the quality characteristic for MRR is set to high...
متن کاملMulti-objective optimization and analysis of electrical discharge machining process during micro-hole machining of D3 die steel employing salt mixed de-ionized water dielectric
Correct selection of manufacturing condition is one of the most important aspects which should be considered in the majority of manufacturing processes, particularly in the process related to advanced machining process like electrical discharge machining. In electrical discharge machining (EDM), dielectric fluid plays an important role since machining characteristics are greatly influenced by ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2019
ISSN: 2321-9653
DOI: 10.22214/ijraset.2019.5377