Experimental investigation of tribological characteristics and emissions with nonedible sunflower oil as a biolubricant

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental analysis of tribological properties of biolubricant with nanoparticle additive

This study examined the tribological properties of two lubricating oils, paraffin oil and biolubricant added with TiO2 nanoparticles used as additives. Biolubricant used in this experimental was derived from palm oil-based TMP (trimethylolpropane) ester. The TMP ester is produced from palm oil, which is biodegradable and has high lubricity properties such as a higher flash point temperature and...

متن کامل

Experimental investigation into tribological characteristics of bio- lubricant formulated from Jatropha oil

The investigation of Lubricated Friction and Wear is an extended study. The aim of this study is to investigate the friction and wear characteristics of Jatropha oil based biolubricant by using Cygnus Wear Testing Machine under load of 30N, a high rotating speed of 2000 rpm and one hour operation time. In this study, SEA 40 was used as a reference base lubricant. As a biolubricant various blend...

متن کامل

The tribological properties of zinc borate ultrafine powder as a lubricant additive in sunflower oil

This paper presents an investigation on the tribological properties of zinc borate ultrafine powder (ZBUP) employed as a lubricant additive in sunflower oil. The stable dispersions of 0.5 wt%, 1 wt% and 2 wt% ZBUP in sunflower oil were achieved by using an ultrasonic homogenizer. Both a 4-ball tester and a pin-on-disc tester were employed to evaluate the antiwear and friction reduction capabili...

متن کامل

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Air & Waste Management Association

سال: 2018

ISSN: 1096-2247,2162-2906

DOI: 10.1080/10962247.2018.1523070