Experimental Optimization of Process Parameters with Wire-EDM on Inconel 625
نویسندگان
چکیده
منابع مشابه
Modeling and Optimization of Wire EDM Process
The present work is aimed to optimize the parameters of (WEDM) process by considering the effect of input parameters viz. Time On, Time Off, Wire Speed & Wire Feed. Experiments have been conducted with these parameters in three different levels data related to process responses viz. Metal removal rate, surface roughness (Ra) have been measured for each of the experimental run. These data have b...
متن کاملExperimental Investigation of Wire-EDM Process Parameters on MRR of Ti-6al-4v Alloy
The objective of the present work was to investigate the effect of the wire electrical discharge machining process parameters on material removal rate of titanium alloy using Taguchi approach. A brass wire of 250μm was applied as a tool electrode to cut the specimen. L36 mixed orthogonal array (2 ×3) has been selected for experimentation under different variables like dielectric conductivity, p...
متن کاملOptimization of EDM Process Parameters: A Review
Electrical Discharge Machining performance is generally evaluated on the basis of Material Removal Rate (MRR), Tool Wear Rate (TWR), Relative Wear Ratio (RWR) and Surface Roughness (SR). The important EDM machining parameters affecting to the performance measures of the process are discharge current, pulse on time, pulse off time, arc gap, and duty cycle [9]. A considerable amount of work has b...
متن کاملOptimization of machining parameters of EDM while machining Inconel 718 for form tolerance and orientation tolerance
This paper demonstrates the effectiveness of optimizing multiple characteristics of electrical discharge machining (EDM) of Inconel 718 using copper electrodes having different shapes via Taguchi method-based Grey analysis. The modified algorithm adopted here is used successfully for both detraining the optimum settings of machining parameters and for combining multiple quality characteristic i...
متن کاملOptimization of Process Parameter of Wire Electrical Discharge Machine by Response Surface Methodology on Inconel-600
in the present paper, the study has been made to optimize the process parameters during machining of Inconnel-600 by wire electrical discharge machining (WEDM) using response surface methodology (RSM). Four input process parameters of WEDM (namely Peak Current (IP), Pulse-On time (TON), Pulse-Off time (TOFF) and Wire Feed rate (WF)) were chosen as variables to study the process performance in t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2019
ISSN: 2321-9653
DOI: 10.22214/ijraset.2019.10065